English | 7
Bosch Power Tools 1 619 X05 390 | (25.11.10)
f Use suitable detectors to determine if utili-
ty lines are hidden in the work area or call
the local utility company for assistance.
Contact with electric lines can lead to fire
and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line
causes property damage or may cause an
electric shock.
f Do not operate the power tool stationary. It
is not designed for operation with a saw table.
f Do not use high speed steel (HSS) saw
blades. Such saw blades can easily break.
f Do not saw ferrous metals. Red hot chips
can ignite the dust extraction.
f When working with the machine, always
hold it firmly with both hands and provide
for a secure stance. The power tool is guided
more secure with both hands.
f Secure the workpiece. A workpiece clamped
with clamping devices or in a vice is held
more secure than by hand.
f Always wait until the machine has come to
a complete stop before placing it down. The
tool insert can jam and lead to loss of control
over the power tool.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with
internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets,
it should be cut off and an appropriate plug fit-
ted in its place by an authorised customer serv-
ice agent. The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be in-
serted into a mains socket elsewhere.
Products sold in AUS and NZ only: Use a resid-
ual current device (RCD) with a rated residual
current of 30 mA or less.
Functional Description
Read all safety warnings and all in-
structions. Failure to follow the
warnings and instructions may re-
sult in electric shock, fire and/or se-
rious injury.
Intended Use
The machine is intended for lengthways and
crossways cutting of wood with straight cutting
lines as well as mitre cuts in wood while resting
firmly on the workpiece. With suitable saw
blades, thin-walled non-ferrous metals, e. g.,
profiles, can also be sawed.
Working ferrous metals is not permitted.
Product Features
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1 On/Off switch
2 Lock-off button for On/Off switch
3 Spindle lock button (PKS 1500)
4 Auxiliary handle (insulated gripping surface)
5 Scale for mitre angle
6 Wing bolt for parallel guide*
7 Wing bolt for bevel-angle preselection
8 Cutting mark, 45°
9 Cutting mark, 0°
10 Parallel guide*
11 Retracting blade guard
12 Base plate
13 Lever for retracting blade guard
14 Blade guard
15 Handle (insulated gripping surface)
16 Saw spindle
17 Mounting flange
18 Saw blade*
19 Clamping flange
20 Clamping bolt with washer
21 Ring spanner
22 Clamping lever for cutting-depth preselec-
tion
23 Set of screw clamps*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
OBJ_BUCH-1089-002.book Page 7 Thursday, November 25, 2010 8:04 AM
(32 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals