Bosch PKP 7.2 LI Service Manual download pdf (Page 17)

English | 17

Bosch Power Tools 1 609 929 W64 | (8.7.10)

Assembly

Battery Charging (see figure A)

f Observe the mains voltage! The voltage of the power supply

must correspond with the data given on the nameplate of the

battery charger. Battery chargers marked with 230 V can also

be operated with 220 V.

The battery is supplied partially charged.

To ensure full battery capacity, completely charge the battery (at

least 1.5–2 hours) before using for the first time.

The glue gun cannot be used during the charging procedure; it is

not defective, when it does not function during the charging pro-

cedure.

The lithium ion battery can be charged at any time without reduc-

ing its service life. Interrupting the charging procedure does not

damage the battery.

The “Electronic Cell Protection (ECP)” protects the lithium ion

battery against deep discharging. When the battery is discharged,

the glue gun is switched off by a protective circuit: The glue is no

longer heated.

After the automatic shut-off of the glue gun, do

not press the On/Off button again. The battery

could become damaged.

– Plug the mains plug of the charger 2 into a socket outlet. After-

wards, place the glue gun into the charger cradle.

Disconnect the battery charger from the mains supply when not

using it for longer periods.

f Protect the battery charger against moisture!

Observe the notes for disposal.

Battery Charge

Indicator

red green Meaning

–  The battery is being charged

– { The battery is fully charged

 –

The battery has less than 30% of its

capacity and should be charged

{ – The battery is completely discharged

 Flashing { Continuous light

ARN

OBJ_BUCH-1210-001.book Page 17 Thursday, July 8, 2010 3:18 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

No comments

Bosch PKP 7.2 LI Service Manual Page 17