Bosch SGE53U52UC Instruction Manual download pdf (Page 22)

20

Troubleshooting Guide

Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The

following information may help you with a dishwasher problem without involving a repair professional.

Problem Cause Action

Dishwasher

does not

start

1. Door may not be properly latched.

2. Unit may not be turned on.

3. Unit not reset or previous cycle not com-

pleted.

4. Delay start engaged.

5. Interruption of electrical power supply to

dishwasher or blown fuse.

6. The door may have been closed without

first selecting a cycle.

7. Water supply may not be turned on.

1. Shut the door completely.

2. Press the main power switch to turn unit

on.

3. To reset, refer to “Operating the Dish-

washer” in this manual.

4. To reset, refer to “Delay Start” section in

this manual.

5. Check circuit breaker.

6. Select a cycle and press start.

7. Check and turn on water supply.

Dishwasher

beeping

(end of cycle

signal)

1. Default factory settings alert the cus-

tomer that the cycle is complete by beeping.

This feature can be deactivated if so desired.

2. Water connection is lost.

1. To adjust the volume or deactivate, refer to

the “Cycle Completion Signal” section in this

manual.

2. Check and turn on water supply.

Display does

not illumi-

nate or con-

sole lights

are not on

1. A fuse may have been blown or circuit

breaker tripped.

2. Door not closed or latched.

1. Check the fuse or circuit breaker box and

replace the fuse or reset the breaker if neces-

sary.

2. Ensure door is properly latched and com-

pletely closed.

Dishwasher

seems to run

a long time

1. Incoming water is not warm enough.

2. Cycle time can vary due to soil and water

conditions.

3. Rinse aid dispenser is empty.

4. Dishwasher connected to cold water sup-

ply.

Note: Refer to “Wash Cycle Information” section

in this manual for typical cycle lengths.

1. Before starting a cycle, run hot water fau-

cet at the sink closest to the dishwasher.

2. Sensors in the dishwasher automatically

increase the cycle time to ensure a good wash

when heavy soil is detected.

3. Add rinse aid.

4. Verify dishwasher is connected to hot

water supply plumbing.

Dishes are

not getting

clean

enough

1. Spray arm movement obstructed.

2. Spray arm nozzles clogged.

3. Improper use of detergents.

4. Filters could be clogged.

5. Dishes are nested or loaded too close

together.

6. Selected wash cycle is not suitable for

food soil conditions.

1. Ensure that spray arm movement is not

blocked by hand rotating spray arms before

starting cycle.

2. Remove the spray arms and clean accord-

ing to the “Care and Maintenance” section of

the manual.

3. Increase or decrease detergent depending

on the water hardness (refer to Table 1).

4. Clean the filters according to the “Care and

Maintenance” section of the manual.

5. Rearrange load such that water spray can

reach all items in the dishwasher - see “Load-

ing the Dishwasher” section of the manual.

6. Refer to “Wash Cycle Information” section

of the manual.

1 ... 21 22 23 ... 56

Comments to this Manuals

No comments