Bosch SHU53E User Manual download pdf (Page 29)

English

28

ELECTRICAL CONNECTION

(continued)

WARNING: FIRE HAZARD - LOOSE

OR IMPROPER ELECTRICAL CONNEC-

TIONS CAN CAUSE FIRE. MAKE CER-

TAIN THAT ALL ELECTRICAL CONNEC-

TIONS ARE PROPERLY MADE.

• Do not pre-twist the wires before

connecting them with wire nuts.

• Extend the dishwasher’s stranded

wires 1/8” (3mm) beyond the power

supply cable’s solid wires, as shown in

Figure 28.

5) Using the supplied wire nuts,

connect the electrical supply wires to

the dishwasher’s wires, black to black,

white to white, and green or bare to

green or bare. Make certain that the

insulated wires show no bare wire from

the bottoms of the wire nuts. Gently tug

the wires to make certain they are

securely connected.

6) Press the wires into the junction box.

Make certain that the wire nuts do not

loosen.

7) Place the cover on the juction box

and secure it to the junction box with

the supplied screw.

DOOR TENSION ADJUSTMENT

(only

on SHI and SHV models)

After the dishwasher is installed, open

and close the door several times to

make sure that it does so with ease. If

the door closes too quickly or if the door

falls open, the spring tension needs to

be adjusted.

To Adjust the Spring Tension:

1) Obtain the provided Door Tension

Screws (Figure 1, letter K) from the SHI/

SHV parts bag.

2) Insert the screws as shown in

Figure 29. Turning the screw clockwise

increases the spring tension. Turning

the screws counter-clockwise

decreases the spring tension.

BASE AND TOE PANEL

Regular Toe Panel Installation

Use the toe panel screws (Figure 1,

letter D) from the Dishwasher Installa-

tion Kit and a Torx screwdriver to install

the toe panel as shown in Figure 30.

(Continued on next page)

Figure 29/Ilus. 29

Base and Toe Panel | Base et Panneau inférieur | Base y Panel de Pie

1/8”

Figure 28/Ilus. 28

3mm

Figure 30/Ilus. 30

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments