Bosch CSG15 Use and Care Manual download pdf (Page 8)

SLIDE ON-OFF SWITCH WITH LOCK

The tool is switched “ON” by the switch

button located at the side of the motor

housing. The switch can be locked in the

“ON” position, a convenience for long

grinding operations.

TO TURN THE TOOL “ON” without locking

it, slide the switch button forward by

applying pressure ONLY at the REAR

portion of the button. When pressure is

released the switch button will snap to

“OFF” position.

TO LOCK THE SWITCH “ON”, slide the

switch button forward and press “IN” the

FRONT portion.

TO UNLOCK THE SWITCH, simply press

and release the REAR portion of the button.

Switch is spring loaded and will snap back

automatically.

Hold the tool with both

hands while starting the

tool, since torque from the motor can cause

the tool to twist.

Start the tool before applying to work and let

the tool come to full speed before

contacting the workpiece. Lift the tool from

the work before releasing the switch. DO

NOT turn the switch “ON” and “OFF” while

the tool is under load; this will greatly

decrease the switch life.

ELECTRONIC FEEDBACK CIRCUITRY (EFC)

The internal electronic feedback system

provides a "soft start", which will reduce the

stresses that occur from a high torque start.

The system also helps to keep the no load

speed virtually constant between no-load

and load conditions.

OVERLOAD PROTECTION

Your tool is equipped with overload

protection to protect the motor. If the tool

stops during operation TURN OFF SWITCH

IMMEDIATELY and allow the motor to cool

for about 30 seconds by running at no-load.

If the overload protection stops the tool

repeatedly, excessive force is causing the

tool to overload. Don't press so hard and let

the tool do the work.

DUST EXTRACTION

This tool must only be used

with a dust extraction

system. In addition, always wear approved

dust mask.

Your tool is equipped with a dust port for

dust extraction. To use this feature, attach

vacuum hose (optional accessory) to the

dust port, and connect the opposite end of

the hose to a shop vacuum cleaner.

Always make sure the vacuum cleaner that

you use is designed for extraction of

masonry dust.

AUXILIARY HANDLE

The auxiliary handle, used to guide and

balance the tool can be bolted to either side

of the spindle housing depending on

personal preference and comfort. Always

use the auxiliary handle for maximum control

and ease of operation.

-8-

Tool Tips

!

WARNING

Operating Instructions

This tool is intended for grinding, deburring

and smoothing mainly mineral materials

such as, for example, concrete, stone,

marble and poured flooring without the use

of water. It also can be used for removing

protective coating and adhesive residue.

Do not use water or other cooling fluid with

this tool for grinding.

Allow the tool to reach full speed before

applying it to the workpiece surface.

!

WARNING

BM 3609929777 1/02 1/3/02 1:16 PM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments