Bosch GPL5 Service Manual download pdf (Page 13)

-13-

Square 10. If distance Y equals distance Z, then

the two surfaces are square. If distance Y

does not equal distance Z, then adjust the

position of the surface which these

distances relate to until distance Y does

equal distance Z.

Note: The plumb beams can also be used in

operations such as squaring window frames.

To fasten the tool on the Multiple-Purpose

Attachment 8, screw the locking screw 9 of

the Multiple-Purpose Attachment into the

1/4" tripod mount 6 on the tool and tighten.

To rotate the tool on the Multiple-Purpose

Attachment, slightly loosen the screw 9.

– Rotate the tool on the Multiple-Purpose

Attachment 8 sideward or toward the rear

to make the bottom plumb beam visible.

– Rotate the tool on the Multiple-Purpose

Attachment 8 to project heights with the

horizontal laser beam.

With the Multiple-Purpose Attachment 8, the

tool can be attached as follows:

– Mount the Multiple-Purpose Attachment 8

to a commercially available camera tripod

via the 1/4" tripod mount 13. For fastening

to a commercially available construction

tripod, use the 5/8" tripod mount 14.

– The Multiple-Purpose Attachment 8 can be

fastened to steel parts via the magnets 12.

– The Multiple-Purpose Attachment 8 can be

fastened to drywall or wood walls with

screws. For this, insert screws with a

minimum length of 2 in. into the screw

holes 10 of the Multiple-Purpose

Attachment.

– The Multiple-Purpose Attachment 8 can

also be fastened to pipes or similar beams

using a commercially available strap by

threading it through the opening 11 for

strap attachment.

Working with the Tripod (Optional

Accessory)

A tripod 18 offers a stable, height-adjustable

measuring support. Place the tool via the

tripod mount 6 onto the 1/4-20 and 5/8-11

male thread of the tripod and screw the

locking screw of the tripod tight.

Working with the Measuring Plate

(Optional Accessory)

With the measuring plate 15, it is possible to

project the laser mark onto the floor or the

laser height onto a wall.

With the zero field and the scale, the offset or

drop to the required height can be measured

and projected at another location. This

eliminates the necessity of precisely adjusting

the tool to the height to be projected.

The measuring plate 15 has a reflective

coating that enhances the visibility of the

laser beam at greater distances or in intense

sunlight. The brightness intensification can

be seen only when viewing, parallel to the

laser beam, onto the measuring plate.

Laser Viewing Glasses (Optional

Accessory)

The laser viewing glasses filter out the

ambient light. This makes the red light of the

laser appear brighter for the eyes.

• Do not use the laser viewing glasses as

safety goggles. The laser viewing glasses

are used for improved visualization of the

laser beam, but they do not protect against

laser radiation.

• Do not use the laser viewing glasses as

sun glasses or in traffic. The laser

viewing glasses do not afford complete UV

protection and reduce color perception.

Use with Attachments

B

Y

A

Z

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comments to this Manuals

No comments