Bosch GSL 2 Use and Care Manual download pdf (Page 16)

-16-

Store and transport the

tool only in the supplied

protective case.

Keep the tool clean at all times.

Do not immerse the tool into water or

other fluids.

Wipe off debris using a moist and soft

cloth. Do not use any cleaning agents

or solvents.

Regularly clean the surfaces at the exit

opening of the laser in particular, and

pay attention to any fluff of fibers.

If the tool should fail despite the care

taken in manufacturing and testing

procedures, repair should be carried

out by an authorized after-sales service

center for Bosch power tools.

In all correspondence and spare parts

orders, please always include the

10-digit article number given on the

type plate of the tool.

In case of repairs, send in the tool

packed in its protective case.

ENVIRONMENT PROTECTION

Recycle raw materials & batteries

instead of disposing of waste.

The unit, accessories, packaging &

used batteries should be sorted for

environmentally friendly recycling in

accordance with the latest regulations.

Maintenance and Service

!

WARNING

FCC Caution:

The manufacturer is not responsible for

radio interference caused by unauthorized

modifications to this equipment. Such

modifications could void the user’s

authority to operate the equipment.

This device complies with Part 15 of the

FCC Rules. Operation is subject to the

following two conditions:

1) This device may not cause harmful

interference, and

2) This device must accept any

interference received, including

interference that may cause undesired

operation.

Note! This equipment has been tested

and found to comply with the limits for

a Class B digital devices, pursuant to

Part 15 of the FCC rules. These limits

are designed to provide reasonable

protection against harmful interference in

a residential installation. This equipment

generates uses and can radiate radio

frequency energy and, if not installed and

used in accordance with the instructions,

may cause harmful interference to radio

communications.

However, there is no guarantee that

interference will not occur in a particular

installation. If this equipment does cause

harmful interference to radio or television

reception, which can be determined

by turning the equipment off and on,

the user is encouraged to try to correct

the interference by one or more of the

following measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet

on a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 47 48

Comments to this Manuals

No comments