Bosch GCM12SD Use and Care Manual download pdf (Page 23)



Adjustments

'< .C<61 =<@@6/92 6;7B?F

6@0<;;20A =9B4 3?<: =<D2?

@<B?02 /23<?2 =2?3<?:6;4 .;F .@@2:/9F

.17B@A:2;A<??2=.6?

52086;4H2C29&A<=&2AA6;4

. Hold the saw head assembly down and push in

the head assembly lock pin (item 43 – page 9) to

keep the saw in the DOWN position.

2. Slide the head assembly completely to the back

and engage the lock lever (item 27 – page 9) by

lifting up the finger tab.

3. Rotate the table to the 0° miter position.

4. Pull up the bevel lock lever to unlock. Move the left

sliding fence fully to the left.

5. Check the position of the bevel range selector

knob; it should be at the “0-45° Left” position.

6. Tilt the saw assembly to the left

(counterclockwise) until it hits the 45° stop – this is

where the saw’s 45° stop is set to make a 45° left

bevel cut.

7. Use a combination square to check that the blade

is 45° to the table. Remove the rule blade from the

combination square. Place only the combination

square’s head on the saw’s table with its long flat

side resting on the table and its 45° side against

the tilted blade (see Figure 24).

64B?2

8. Check that only the saw blade’s plate (not teeth) is

touching the square’s 45° side. If the saw blade’s

plate is not in full contact with the square’s head

45° side, follow the “Adjusting 45° Bevel Stop”

procedures.

Contacting Table

Contacting

Blade

Combination

Square Head

*%""

H2C29&A<=J17B@A:2;A$?<021B?2

BM 2610007877 08-10:BM 2610007877 08-10.qxp 8/24/10 1:04 PM Page 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 163 164

No comments

Bosch GCM12SD Use and Care Manual Page 23