Bosch LTC 5104 Instruction Manual download pdf (Page 10)

Bosch Security Systems | 7 April 2004

LTC 5104, LTC 5108 Series | Instruction Manual | Installation

•To abort and resume normal operation, press

DWELL.

•To reset to factory defaults, press SKIP/clr,

moving the cursor to RESET, then press

DWELL. This option also performs a

VideoSearch.

NOTE: Resetting the unit to factory defaults will not

reset the title characters to be blank.

4.8 Dwell Time

This menu (see SCREEN 1) is used to program dwell

times of 1 second to 64 seconds for the cameras. There

are two modes of dwell that may be chosen; All

Cameras and Individual Cameras. All Cameras mode sets

the displayed dwell time for all four or eight cameras.

Individual Cameras mode sets the displayed dwell time

for only the camera number indicated on-screen. Upon

entry into the Dwell Time menu, the dwell mode

defaults to All Cameras. The Individual Cameras mode is

entered using the numeric keys or the RUN/next key.

RUN/next key selects individual camera dwell times

by sequencing forward. Each numeric key selects that

particular camera input. The video of the selected

individual camera will be displayed (on the monitor

for LTC 5104 Series, or on both monitors for the

LTC 5108 Series), provided the camera input has not

been skipped. If a camera input is skipped, its dwell

time menu can be entered but the unit will not switch

video to that camera input. Since no dwell menu can

be displayed if there is no video to that input, it is

recommended to skip all camera inputs without video

before attempting to set individual dwell times. Once

in Individual mode, the Dwell Time menu must be

exited and re-entered if All Cameras mode is desired.

SKIP/clr decreases displayed dwell time, and

ALARM increases dwell time. The default is All

Cameras with a dwell of three seconds.

4.9 Operating Mode

LTC 5108 Series Only

Two modes of operation can be selected for the

LTC 5108 Series switchers (see SCREEN 2). The two

modes only affect Monitor B; Monitor A continuously

sequences regardless of mode. In the Sequencing Mode,

Monitor B will show either an alarm call up of a

camera, a camera under a Hold condition, or normal

sequencing of cameras. In the Blanking Mode,

Monitor B will show either an alarm call up of a

camera, a camera under a Hold condition, or a blank

screen.

4.10 Alarm Reset Mode

There are two Alarm Reset modes, AUTO and MANUAL

(see SCREEN 4). In the AUTO reset mode, alarm

call ups automatically reset after the Alarm Capture

Time has expired. In the MANUAL reset mode, alarm

call ups are held until manually reset via SKIP/clr.

SKIP/clr toggles the selection pointer between the

two modes. The default is AUTO.

Screen 4

Operating Modes

Monitor A Monitor B

Sequencing Mode

1. Normal sequencing of

camera inputs

1. Normal sequencing

(same as Monitor A)

2. HOLD condition

3. ALARM condition

Blanking Mode

1. Normal sequencing

of camera inputs

1. Blank screen

2. HOLD condition

3. ALARM condition

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Bosch LTC 5104 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Network switches Bosch LTC 5104