Bosch DX4010V2 Specifications download pdf (Page 5)

DX4010V2 | Installation Instructions | 4.0 Wiring

Bosch Security Systems, Inc. | 9/08 | F01U083036-01 5

1. Disconnect power to the control panel by

unplugging the transformer and removing the red

battery lead.

2. Remove screws from enclosure cover to access

the DX4010V2 board.

3. Connect circuit wiring and install jumper pins.

Refer to Section 4.0 Wiring on page 5.

4. Replace enclosure cover.

5. Connect a serial cable to the serial device. Refer

to Section 7.0 DB9 DTE RS-232 Connector (P6)

on page 10.

6. Reapply power to the control panel.

4.0 Wiring

Remove all power to the control panel (AC

and standby battery) before making or

breaking any connections. Failure to do so

can result in personal injury or damage to

the equipment.

Wire Length Restrictions

• 0.8 mm (#22 AWG): 305 m (1000 ft)

• 1.2 mm (#18 AWG): 610 m (2000 ft)

• USB or Serial Cables are not to exceed 2 meters

(6 ft) in length.

SDI option bus wiring is limited to 305 m

(1000 ft).

Connect the DX4010V2 to the control panel data and

auxiliary power sources as shown in Figure 2.

Figure 2: Control Panel Connections

1- DX4010V2 data bus

2- Control panel data bus

3- Option AUX common/SDI common (black)

4- Option data/SDI B (green)

5- Option data/SDI A (yellow)

6- Option AUX power +/SDI power (red)

If an external 12 VDC power supply is used, wire as

shown in Figure 3.

Figure 3: External Power Supply Connections

1- DX4010V2 data bus

2- Control panel data bus

3- Option AUX common/SDI common (black)

4- Option data/SDI B (green)

5- Option data/SDI A (yellow)

6- Option AUX power +/SDI power (red)

7- External 12 VDC power supply

Figure 4 shows serial device-to-DX4010V2

connections using the DB9 DTE RS-232 connector

(P6).

Figure 4: Serial Device Connections

SER

RxTx

BUS

RxTx

LED

DB9 GND

ENABLE

1- Serial (RS-232) device such as a PC (with

RPS, BIS, PC9000, or other third party

application) or a serial printer for supported

control panels.

Refer to Section 7.0 DB9 DTE RS-232

Connector (P6) on page 10 for additional

information.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comments to this Manuals

No comments

Bosch DX4010V2 Specifications Page 5

Comments to this Manuals

Related products and manuals for Networking Bosch DX4010V2