Bosch Mastertech M-VCI Installation Guide download pdf (Page 4)

Robert Bosch LLC M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009

M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | June 2009 Robert Bosch LLC

Getting Started | 43 | Getting Started

Step B – Identifying your IP

Address Type

Start with a computer that is

currently running on your existing

network. To determine if your

computer network is using Static

or Dynamic IP’s:

Click: The Windows 1.

Start Button

Click: Run2.

1. 2.

3. Enter: “cmd” into the Run

window (without quotes)

Click: OK4.

3. 4.

Important: Before proceeding

with this step, be sure your PC

is connected to your network or

to your modem. If you are using

a wireless or stand alone PC,

connect the new NETGEAR Router

to your PC LAN port with the

provided Ethernet cable.

Step C – At the MS-DOS

Prompt – Check DHCP

Type: “ipcong/all” (without 1.

quotes) into the command

window

Compare output to the 2.

examples below

Output must include the line 3.

“DHCP Enabled… Yes”

Also verify that “DHCP Server” 4.

is present

The actual numbers for the IP

addresses are irrelevant

If your output matches the output

above then you may continue this

guide.

If DHCP Enabled = No, then

additional steps must be taken

to congure the M-VCI. (See

Appendix A – Static Network

Reference Guide)

Step D – Choosing your

Setup type and Special

Instructions

Type I (Current setup w/router.

Existing router as DHCP server)

Type II (Current setup w/DSL or

cable modem and no router. The

ISP is the DHCP server)

Type III (No internet connection)

If your setup looks most like Type

I - Follow Instructions & “Special

Instructions for Type I”

If your setup looks most like Type

II - Follow Instructions & “Special

Instructions for Type II”

If your setup looks most like Type

III - Follow Instructions & “Special

Instructions for Type III”

The M-VCI – NETGEAR Router

install procedure is similar

for all types. When a “Special

Instruction” is called out, please

follow the one pertaining to your

setup type.

The Type III has no internet

connection but uses the

NETGEAR Router to enhance

M-VCI to PC wireless

communication.

Example – Final Setup

Conguration for Type I

This shows the new NETGEAR

pre-congured router installed

into a network (Setup Type I) with

a pre-existing wireless router. No

network changes need to be made

to existing routers or computers.

Do not perform this nal set up

until directed to do so. You need

to congure your new NETGEAR

Router rst.

Example – Final Setup

Congurations for Types II

& III

1 2 3 4 5 6 7 8 9 10

Comments to this Manuals

No comments

Bosch Mastertech M-VCI Installation Guide Page 4

Comments to this Manuals

Related products and manuals for Networking Bosch Mastertech M-VCI