Bosch LTC 2210 User Manual download pdf (Page 6)

LTC 2210 Series | Instruction Manual | Unpacking

Bosch Security Systems | December 17, 2004

1.0 UNPACKING

This equipment should be unpacked and handled with

care. If an item appears to have been damaged in

shipment, notify the shipper.

Verify that all parts shown in the Parts List have been

included. If any items are missing, notify your Bosch

Security Systems Sales or Customer Service

Representative.

The original packing carton is the safest container in

which to transport the unit. Save it for possible future

use.

1.1 Parts List

2.0 SERVICE

If the unit needs repair, contact the nearest Bosch

Security Systems Service Center for authorization to

return and shipping instructions.

Service Centers

USA

Phone: 800-366-2283 or 717-735-6638

Fax: 800-366-1329 or 717-735-6639

CCTV Spare Parts

Phone: 800-894-5215 or 408-956-3853 or 3854

Fax: 408-957-3198

E-mail: [email protected].com

Canada

Phone: 514-738-2434

Europe, Middle East & Asia Pacific Region

Phone: 32-1-440-0711

For additional information, see

www

.boschsecurity.com.

3.0 DESCRIPTION

The LTC 2210 Series video motion detectors utilize

edge detection with digital tracing technology. Patented

circuitry provides reliable security surveillance

protection. These economical, full featured single

channel detectors provide flexible operation to

maximize performance and minimize false alarms.

Motion is detected over the full active video for NTSC,

PAL and SECAM.

4.0 INSTALLATION

4.1 Power

Model LTC2210/60 LTC 2210/50

Rated Voltage 120 VAC, 50/60 Hz 230 VAC, 50/60 Hz

Voltage Range 105 to 130 195.5 to 253

Power at rated voltage

5 W 5 W

4.2 Mounting

These motion detectors are supplied as desk top half-

rack units. For rack mounting, the LTC 9101/00 rack-

mount kit is available.

4.3 Video Looping Input

There are two smart BNC connectors on the rear

panel named IN and LOOP. The camera input should

be connected to IN while LOOP may be used as a

looping output. The camera input is automatically

terminated (nonlooping operation) or unterminated

(looping operation).

4.4 Monitor Output

The monitor output, named OUT, is designed for a

75 Ω load. Therefore if the monitor output cable is

looped through other accessories, ensure that the last

unit on the line has its termination set to 75 Ω

Qty Item

1 Unit (verify model number)

1 One (1) 15-pin cable assembly

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Bosch LTC 2210 User Manual Page 6

Comments to this Manuals