Bosch DVA-12T Installation Guide download pdf (Page 7)

RAID Subsystem DVA-12T | Quick Installation Guide Installation Procedures | en 7

Bosch Security Systems F.01U.027.801 | V2 | 2006.07

3 Installation Procedures

To install the subsystem use the following steps:

1. Unpack the Subsystem (see Section 4 Unpacking the Subsystem)

2. Install the system in the rack (see Section 5 Rack Mounting)

3. Install the Drive Tray (see Section 6 Drive Tray Installation)

4. Connect the Subsystem Cable (see Section 7 Subsystem Cable Connections)

5. Power On (see Section 8 Power On)

6. Configure the Host Computer (see Section 9 Configuring the Host Computer via a Network)

7. Change the IP Address (see Section 10.1 Changing an IP Address)

8. Change the factory default settings (see Section 10.2 Guidelines for Setting Up a RAID)

9. Connect a Bosch Video Server (see Section 12 Connecting a Bosch Video Server)

4 Unpacking the Subsystem

Check the included Unpacking Checklist and verify the model name and shipping contents

against the checklist.

5 Rack Mounting

Slide rails are required for rack mounting. For rack mounting use only one of the following

slide rail kits:

DVA-12T

Slide rails for 533 mm to 724 mm deep racks

(21" to 28.5")

DVA-ASRK-28A

Slide rails for 647 mm to 914 mm deep racks

(25.5" to 36")

DVA-ASRK-36A

Table 5.1 Slide rail kits

NOTICE!

Refer to Slide Rail Kit Installation Manual for detailed information.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Bosch DVA-12T Installation Guide Page 7