Bosch EX65 Instruction Manual download pdf (Page 21)

22 en | Mounting EX65 Explosion-protected Illuminator

F.01U.162.949 | 1.0 | 2011.03 Instruction Manual Bosch Security Systems, Inc.

5. Slightly loosen the six M6 bolts on both sides of the mounting cradle, using a 10mm

wrench or the supplied multi-use tool, and make directional adjustments to the EX65 so

that it is pointing at the desired surveillance target (see the graphics below).

6. Tighten all mounting bolts to 3 to 5 ft-lb (4.1 to 6.8 N·m).

7. Connect wiring as explained in Section 5 Connections, page 17, and follow all local

regulations and laws regarding explosion protected devices.

8. Connect the ground cable, located on the bottom of the housing, to a suitable grounded

material (grounded conduit or a ground wire).

7.2 Installing the Sunshield

1. Line up the mounting holes of the sunshield with the tapped holes in the body of the

EX65.

2. Install the supplied M4 bolts through the sunshield bolt holes into the body of the unit

and tighten by hand.

3. Tighten the supplied bolts to 1.5 ft/lb (2.0 N/m) using a 7 mm wrench or the supplied

multi-use tool.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

No comments

Bosch EX65 Instruction Manual Page 21