Bosch KBE-335V55-20 Instruction Manual download pdf (Page 6)

vi en |

Bosch Security Systems, Inc.

For Indoor Product

1. Water and Moisture - Do not use this unit near water -

for example, in a wet basement, in an unprotected out-

door installation or in any area classified as a wet loca-

tion.

2. Object and Liquid Entry - Never push objects of any

kind into this unit through openings, as they might touch

dangerous voltage points or create short circuits, result-

ing in a fire or electrical shock. Never spill liquid of any

kind on the unit.

3. Power Cord and Power Cord Protection - For units

intended to operate with 230VAC, 50Hz, the input and

output power cord must comply with the latest versions

of IEC Publication 227 or IEC Publication 245. Power

supply cords should be routed so they are not likely to

be walked on or pinched. Pay particular attention to

location of cords and plugs, convenience receptacles,

and the point of exit from the appliance.

4. Overloading - Do not overload outlets and extension

cords; this can result in a risk of fire or electrical shock.

For Outdoor Product

Power Lines - An outdoor system should not be located

in the vicinity of overhead power lines, electric lights or

power circuits, or where it may contact such power lines

or circuits. When installing an outdoor system, extreme

care should be taken to keep from touching power lines

or circuits, as this contact might be fatal. U.S.A. models

only - refer to the National Electrical Code Article 820

regarding installation of CATV systems.

For Rack-mount Product

1. Ventilation - Do not place this equipment in a built-in

installation or rack, unless proper ventilation is pro-

vided, or the manufacturer's instructions were followed.

The equipment must not exceed its maximum operating

temperature requirements.

2. Mechanical Loading - When rack-mounting the equip-

ment, ensure that a hazardous condition is not created

by uneven mechanical loading.

WARNING:

Electrostatic-sensitive device. Use proper CMOS/

MOSFET handling precautions to avoid electro-

static discharge.

NOTE: Grounded wrist straps must be worn and

proper ESD safety precautions observed when

handling the electrostatic-sensitive printed circuit

boards.

This symbol indicates the presence of important

operating and maintenance (servicing) instruc-

tions in the literature accompanying the appli-

ance.

Cover Removal

Warning: Removal of the cover should only be

performed by qualified service personnel - not

user serviceable. The unit should always be

unplugged before removing the cover and remain

unplugged while the cover is removed.

24 VAC Units

Do not exceed 30VAC input. Voltage applied to the unit's

power input should not exceed 30VAC. Normal input voltage is

24VAC. User supplied wiring from 24VAC supply to unit must

be in compliance with electrical codes (Class 2 power levels).

Do not ground 24VAC supply at power supply terminals or at

unit's power supply terminals.

This equipment is to be isolated from the mains

supply by a limited power source as specified in

EN60950.

220-240V, 50Hz Power Cords

220-240V, 50Hz power cords, input and output, must comply

with the latest versions of IEC Publication 227 or IEC Publica-

tion 245.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Bosch KBE-335V55-20 Instruction Manual Page 6

Comments to this Manuals

Related products and manuals for Security cameras Bosch KBE-335V55-20