Bosch LTC-0485-21 Installation Manual download pdf (Page 25)

Dinion

| Installation Manual

Bosch Security Systems | 2003-10 | V0.5

EN | 25

Install I/O --> Alarm submenu

Install sync submenu

Note

VPHASE, HPHASE and SUB-PHASE cannot be accessed if there is no

valid locking signal.

Function Selection Description

ACTIVE NONE, HIGH, LOW Selects active_HIGH or active_LOW for the

alarm input connector. Select NONE to disable

alarm switching.

ACTION NONE, MODE1,

MODE2, MODE3

Selects the operating mode of the camera upon

switching the alarm input.

ALARM

OUT

VMD, REMOTE Select VMD to close the output relay upon VMD

alarms. Select REMOTE to make the output relay

available to remote communication devices.

EXIT Return to the I/O menu

Function Selection Description

SYNC INTERNAL, LINE

LOCK, HV LOCK,

GENLOCK

Select INTERNAL for free running camera

operation, select LINE LOCK to lock to the power

supply frequency, select HV LOCK to lock to the

signal supplied to the external sync input, select

GENLOCK to lock the subcarrier as well.

DETECTED

SYNC

Shows the actual sync mode used by the camera.

VPHASE 0, 2, … 358 Adjusts the vertical phase offset (when in LINE

LOCK mode and a valid power supply frequency

is detected).

HPHASE -25, …, 0, … +125 Adjust the horizontal phase offset (when in EXT

lock mode and a valid input signal is detected)

SUB

PHASE

0, 2, … 358 Adjusts the sub-carrier phase offset (when in EXT

LOCK mode and a valid sub-carrier is detected).

EXIT Return to the INSTALL menu

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

Comments to this Manuals

No comments

Bosch LTC-0485-21 Installation Manual Page 25

Comments to this Manuals

Related products and manuals for Security cameras Bosch LTC-0485-21