Bosch DUH User Manual download pdf (Page 9)

6. For rectangular ducted discharge installations

only (otherwise skip to next step)

Attach exhaust adaptor/damper over knockout

opening with two exhaust adaptor screws. Make sure

damper pivot is nearest to top/back edge of hood.

Remove tape from damper flap.

Exhaust

transition/damper

Pivot

Top/back

edge

NOTE: The exhaust adaptor/damper can be

installed up to 1 inch on either side of the hood

center to accommodate off-center ductwork. In

extreme off-center installations, one end of the duct

connector may need to be trimmed to clear the

electrical cable clamp.

7. For round ducted discharge installations only

Re-install the round transition with its screws.

7" Round

Transition

NOTE: The round transition can be installed up to 1

inch on either side of the hood center to

accommodate off-center ductwork. In extreme off-

center installations, one end of the duct connector

may need to be trimmed to clear the electrical cable

clamp.

1 2 3 4 5 6 7 8 9 10 ... 32

No comments

Bosch DUH User Manual Page 9