Bosch MON152CL30 Instruction Manual download pdf (Page 9)

MON152CL30 | Instruction Manual | Installation

Bosch Security Systems | April 12, 2006

6.3 Wall Mount/Rack Mount

Installation

The square mounting holes (75 mm (2.9 in.) centers)

can be used for rack mount installation or with wall

mount brackets (not provided) (refer to the Rack

Mount Kit Instructions).

6.3.1 Wall Mount Installation

1. Remove the MON152CL30 power supply/base

from the LCD panel section.

a. Unscrew the two (2) holding screws before

separating the base from the panel, as shown

in Photo A.

Photo A

b. Carefully remove the power bayonet

connector (Figure 4, Item 1) from the panel

(see Photo B), while sliding the base off the

monitor.

Photo B

2. Mount the unit to the mounting bracket (not

provided) using the four (4) mounting holes on

the rear panel. The square mounting hole

patterns are standard on 75 mm (2.9 in.) centers,

as shown in Photo C.

Photo C

6.3.2 Extension Cable Installation

Use the Extension Cable (included with the

MON152CL30) to place the power supply/base unit to

1.5 m (5 ft) from the LCD panel for wall mount or

rack mount installations.

1. Follow the instructions in Section 6.3.1, Step 1

to remove the power supply/base from the LCD

panel section.

2. Attach the power supply extension cable.

a. Connect one end of the extension cable

(large connector) to the power supply/base,

as shown in Photo D.

Photo D

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Bosch MON152CL30 Instruction Manual Page 9