Bosch UML-082 User Manual download pdf (Page 29)

Small Size LCD/LED Monitors Navigating the Monitor | en 29

Bosch Security Systems, Inc. User Manual F.01U.134.499 | 1.0 | 2009.07

6.2 Navigating the Monitor On-screen Display

(OSD)

The UML-080-90, UML-100-90, UML-082-90 and the UML-102-

90 have two (2) modes: Video and PC. The LCD is programmed

through the on-screen display (OSD) menus and submenus

where an operator can select operating parameters. To access

the OSD menus, press the Menu button on the front panel. Use

the front panel of the monitor to make any necessary

adjustments to the OSD.

To navigate the set up menus, follow the steps below:

1. Connect the CVBS, S-Video or the VGA cable.

2. Press the Power button to turn on the unit (see

Figure 6.1).

3. If required, press the Input button and the and

buttons until a signal is displayed.

4. Press the Menu button to activate the main menu

selections (see Figure 6.1).

5. Press the and buttons to select a menu.

6. Press the Input button to enter the selected menu.

7. Press the and buttons to select a sub-menu item.

8. Press the Input button to enter the selected sub-menu.

9. Press the and buttons to toggle the OSD values.

10. Press the Menu button to exit the selected menu and to

return to the menu bar or to confirm a selection.

11. Press the Menu button again to exit the OSD menu bar.

NOTICE!

When you are navigating through the OSD menus, use the Input

button to select a menu and use the Menu button to exit a

menu.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

No comments

Bosch UML-082 User Manual Page 29