Bosch 2400ES User Manual download pdf (Page 7)

Remote control installation

6 720 606 990

Fig. 4 Support correct position

B Use the supplied cable to connect

between the main PCB and the

remote control PCB as shown in Fig.

Fig. 5

B Replace the control unit cover with

the 4 Philips head screws (Fig. 3,

pos. 1).

B Slide control unit back into heater.

B Plug 2 yellow electrode wires from

the top of the control unit back onto

the ignition electrodes. Ensure all

connections are secure and tight

(Fig. 2, pos. 3).

B Pull end of power cord to take up

excess slack and tighten retaining

nut on the bottom of the heater.

B Reinstall the two electrical strip

connectors onto the PCB. The

larger connector connects to the

lower connection on the PCB.

Reseat the rubber seals for both

connectors.

B Replace the control unit auxiliary

cover. (Fig. 2, pos. 4).

B Replace front retaining bar using 5

Phillips head screws. (Fig. 2, pos 1).

Wire polarity does not

matter on the electrode

wires.

6720606990-0701_(Remote control)16Nov.fm Page 7 Friday, November 16, 2007 3:04 PM

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Bosch 2400ES User Manual Page 7