Bosch WAT28460GB Instruction Manual

en Instruction Manual and Installation InstructionsWasherWAT...

en Getting to know the appliance10Display panelNote: You will find settings and information for the selected program in the table.*depending on th

Laundry en11Z LaundryLaundryPrepare the laundryCaution!Damage to the appliance/fabricsForeign objects (e.g. coins, paper-clips, needles, nails) may

en Detergent12Dyeing/bleachingDye should only be used in normal household quantities. Salt may damage stainless steel. Always follow the dye manufa

Programme default settings en13Saving energy and detergentFor light and normal soiling, you can save energy (lower washing temperature) and det

en Additional programme settings14stays wet inside the drum, e.g. for items that should not be spun.Setting - - - -: Spülstopp (Rinse Stop) = no fi

Operating the appliance en15Note: Do not exceed the maximum load. EcoEnergy-optimised washing by reducing the temperature while achieving a w

en Operating the appliance16Change the programme default settingsYou can use the default settings for each wash cycle or change them. To do this, r

Operating the appliance en17 The amount of laundry Soiling ~ Page 13Filling:WarningEye/skin irritation!Detergent and care products may spray

en Operating the appliance18Childlock (E 3 sec., E 3 δευτ.)You can lock the washing machine to prevent the functions you have set from being change

Sensors en19 Selecting a spin speed or setting the program selector to 0 Spin/Drain//Spin/Empty [ and then pressing the A button.Programme endEnd

2Your new washing machineYou have selected a washing machine from Bosch. Please take a couple of minutes to read and become familiar with the adva

en Setting the signal20M Setting the signalSetting the signalYou can change the following settings: The volume of the buttons and information si

Cleaning and maintenance en21Machine housing/control panel Wipe the housing and the control panel with a soft, damp cloth. Remove the deterge

en Cleaning and maintenance224. Take the drain hose out of the retainer.Remove the sealing cap, allow the detergent solution to flow out into a sui

Faults and what to do about them. en23Remove the hose from the rear of the appliance.Use pliers to remove the filter and then clean it.7. Conne

en Faults and what to do about them.24Information on the display panelDisplay Cause/Remedyè lights up The temperature is too high. Wait until

Faults and what to do about them. en25Faults and what to do about them.Faults Cause/RemedyWater is leaking from the machine. Attach the drain

en Faults and what to do about them.26Odours in the washing machine.Depending on the model, run the ¾ Drum Clean or i Cottons 90 °C pro-gram wi

After-sales service en274 After-sales serviceAfter-sales serviceIf you cannot rectify a fault yourself, contact customer services. ~ Cover pageWe

en Positioning and connecting28In addition, a hose clamp (24 - 40 mm diameter, available from specialist dealers) is required to connect the water

Positioning and connecting en29Installation surfaceNote: The washing machine be stable so that it does not move around. The installation surf

en3ContentsenInstruction Manual and Installation Instructions8 Intended use. . . . . . . . . . . . . . . . .4( Safety instructions . . . . . . .

en Positioning and connecting30Remove the sleeves. To do this, remove the mains cable from the holders. 3. Fit the covers. Lock the covers firmly i

Positioning and connecting en31 Do not use a used supply hose. Only use the supply hose supplied or one that was purchased from an authorised

en Positioning and connecting32Connection to the applianceConnection of hot water appliances only to cold waterIf there is no hot water connection,

Positioning and connecting en33 Outlet into a plastic pipe with rubber bushing or into a drainage pitLevellingLevel the appliance using a spir

en Positioning and connecting34Before washing for the first timeThe washing machine was thoroughly tested before leaving the factory. To remove any

Positioning and connecting en35 To prevent unused detergent from flowing straight into the drain during the next wash: Pour approx. 1 litre of

Robert Bosch, Hausgeräte GmbHCarl-Wery-Straße 3481739 MünchenDEUTSCHLAND*9000979140*9000979140 (9408)Aqua-Stop warrantyOnly for appliances with Aqua-S

en Intended use44 After-sales service . . . . . . . . . . 27J Technical data . . . . . . . . . . . . . . 275 Positioning and connecting. . . 27Incl

Safety instructions en5( Safety instructionsSafety instructionsElectrical safety:WarningDanger of death!There is a risk of electric shock if you t

en Safety instructions6:WarningDanger of death!Children may lock themselves in appliances, putting their lives at risk.For appliances that have rea

Environmental protection en77 Environmental protectionEnvironmental protectionPackaging/used applianceTips on economical use Always fill the appl

en Getting to know the appliance8* Getting to know the appliance Getting to know the applianceWashing machine6 7#( Detergent drawer ~ Page 16

Getting to know the appliance en9Control panelControl panel depending on the model*depending on the modelNote: The buttons are sensitive, they