Bosch WAW32450GB Instruction Manual download pdf (Page 35)

Programme default settings en

35

0 Programme default

settings

Programme default settings

The default programme settings are

displayed in the display panel after

selecting the programme.

You can change the default settings.

An overview of all programme settings,

which can be selected depending on

the programme, can be found from

~ Page 30.

Temperature

Depending on what stage the

programme is in, you can change the

set temperature before and during the

programme.

The maximum temperature that can be

set depends on the programme that has

been selected.

Spin speed

(Spin)

Depending on what stage the

programme is in, you can change the

spin speed (in rpm; revolutions per

minute) before and during the

programme.

Setting $: Rinse Stop = no final spin.

The laundry stays in the water after the

final rinse.

You can select "Rinse Stop” to prevent

creasing if the laundry will not be taken

out of the washing machine immediately

after the programme has ended.

To continue/end the programme

~ Page 40

The maximum speed that can be set

depends on the model and programme

that has been selected.

Finished In

Before starting the programme, you

can preselect the programme end

("Ready in" time) in hourly increments (h

= hour) up to a maximum of 24 hours.

To do this:

1. Select a programme.

The programme duration is

displayed for the selected

programme, e.g. 2:30

(hours:minutes).

2. Press the Finished In button

repeatedly until the required number

of hours is displayed.

Note: The setting values are

increased using the Finished In +

button, and decreased using the

Finished In - button.

3. Press the A button.

The programme starts.

The selected number of hours

(e.g. 8 h) is shown in the display

panel and counts down until the

wash programme starts. The

duration of the programme is then

displayed.

Note: The length of the programme is

automatically adjusted when the

programme is running. Changes to the

default programme settings or

programme settings may also change

the programme duration.

After starting the programme (if a

Finished In time has been selected and

the wash programme has not yet

started), you can change the

preselected number of hours as follows:

1. Press the A button.

2. Use the Finished In - or + button to

change the number of hours.

3. Press the A button.

After starting the programme, you can

add or remove laundry if necessary.

~ Page 40

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

Comments to this Manuals

No comments