Bosch BC3200RA5 Installation Manual download pdf (Page 11)

11

Installation Instructions

7.

Vent Pipe Installation

• Make sure vent pipe is gas tight and will not

leak. Use heat resistant silicon sealant wher-

ever necessary.

• Do not place any dangerous objects at the end

of the exhaust vent.

• Steam (smoke) or water drops may come out

from the end of the exhaust pipe. Select the

location for the end of the vent so that steam is

not visible, and the vent is not wet with drip-

ping water.

• If snow is expected to accumulate, take care

that the end of the pipe is not covered with

snow or hit by falling lumps of snow.

• Use a maximum of 1m of straight vertical pipe

before the first elbow.

•

Minimum flue length

1 elbow (90 degree) + Flue Terminal.

•Consult the vent pipe manufacturer's install-

ation instructions for chimney connections.

• Do not common vent or connect more than

one appliance to this venting system.

Vent Piping

• Use only Bosch vent materials.

• Follow the vent pipe manufacturer's installation

instructions.

• Make the vertical section of the exhaust vent

as short as possible.

• Maintain the same vent pipe diameter all the

way to the end.

Pipe diameter 100mm

No. of Elbows Max. Straight Vent Length

35m

29m

1 13m

Horizontal Vent Termination

•

Terminate at least 350mm above

ground.

•Terminate at least 2.3m above

a public walkway, 2m from the

combustion air intake of any

appliance, and 1m from any

other building opening, gas

utility meter, service regulator

etc.

• Terminate at least 1m above

any forced air inlet, 1.5m

below, 500mm horizontally

from and 300mm above any

door, window, or gravity air

inlet into any building as per

AS5601.

• Slope the horizontal vent

50mm upwards for every 1m.

• Use a condensation drain if

necessary.

Elbow

Hanger

Straps

Wall

Thimble

Te r mination

1m

Max.

Slope

Upwards

(Indoor Installation Only)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Comments to this Manuals

No comments