Bosch MUM 7400 UC Owner's Manual download pdf (Page 16)

16

The blade assembly may be easily

removed, by inverting the blender,

pressing down on the quick release

handle, turning it counterclockwise until

it stops, as shown in figure 10a, and

then lifting up, see figure 10b.

Figure 10.

Wash the blade assembly under

running water. Do not place the blade

assembly in the dishwasher or allow it

to stand in water. This will tend to wash

out the lubricant. After cleaning, rinse

thoroughly and dry before using.

-

Figure 11.

2. To assemble or reassemble blade

assembly into the blender, insert the

blade assembly into the blender jar as

shown in figure 11, press down on the

quick release handle of the blade

assembly and turn clockwise to the

stop. The blade assembly is then back

in place.

3. If you have not already done so, remove

the motor drive cover and place the

blender on the mono drive. Turn

counterclockwise to lock the blender

in place, see figure 12a.

Placing Blender into Operation

Make sure that the switch is in the Off

position, “O/Off.” Unwind the electrical cord

to the necessary length and plug it into wall

outlet. The blender is now ready for

operation.

Figure 12.

Normally when blending, the blender jar

should be filled with the entire amount of

material to be blended, if possible, before

switching the appliance on. The cover and

cover closure should always be in place after

filling the blender jar, and before switching

the power unit to On. Any subsequent

additions to the blended material should be

made through the cover opening, see figure

13. For solids and/or granular material,

remove the cover closure/funnel to add the

material, as shown in figure 13a. For liquids,

the closure/funnel may be left in place and

the liquids added by pouring them into the

closure/funnel, see figure 13b.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments