Bosch DHI 635 H Operations Instructions download pdf (Page 13)

13

Preparing the wall cupboard

 Ensure that there is a minimum gap

between hob and extractor hood of 650

mm (for gas hobs) or 430 mm (for electric

hobs).

This extractor hood has been designed

for installation inside a wall cupboard with

the following dimensions:

Width: 600 mm

Depth: 280 bis 350 mm

Height: at least 300 mm.

Preparation:

1. Remove bottom panel of cupboard – if

ﬁtted.

 The stability of the cupboard must be

maintained.

2. Mark two points – right and left – on the

inside of the cupboard where the hood

is to be mounted, and start the hole with

a gimlet.

Details for drilling:

l 2 mm – max. 10 mm deep.

Attention:

❑ Use enclosed template

O

II for

marking points where hood is to be

mounted.

❑ The mounting points shown on the

template have been conﬁgured in such

a way as to allow a 20 mm thick handle

to be attached ﬂush with the front edges

of the cupboard.

❑ A stop allows the handle (Dimension ∆)

to be positioned further forwards.

21

32

600

170

280-350

min

d

300.

=

0

0

If the cupboard depth is greater than

280 mm, the hood can be mounted further

back,

. . . if the light strip under the cupboard

. . . units is mounted further back,

. . . if the handle is more than 20 mm thick.

Position the template

O

II further back.

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments