Bosch NGM5055UC Installation Manual download pdf (Page 7)

English 5

Note: The appliance should not be installed with a

ventilation system that blows air downward toward the

burners. This type of ventilation system may cause ignition

and combustion problems with the gas cooking appliance

resulting in personal injury or unintended operation.

Installation Procedure

Prepare the Countertop

Cut out the countertop per the dimensions shown in

“Cabinet Requirements” on page 3.

Some solid surface materials, such as Surell™ and

Corian®, require different cutting methods. Consult with the

solid surface manufacturer for the correct cutting method

needed. Apply heat reflective tape such as Scotch

Aluminum Foil Tape #425 or #427 (not included) around the

cutout so that it folds over on the top and sides. Do not

wrap the tape underneath the cooktop. Be sure the tape

extends beyond the outermost flange of the cooktop. All

corners should be covered with tape.

Seal the Cooktop with Foam Tape

Apply the self adhesive foam tape in one continuous

rectangle directly to the counter around the perimeter of the

cutout as shown by the dotted line in Figure 4: “Counter

Cutout – Foam Tape Placement”. Leave 1/4” (6.35mm) gap

between the foam tape and the edge of the cutout.

Install the Cooktop

Insert cooktop into the cutout. Attach clamps of the hold-

down brackets packaged with the cooktop to the rough-in

box. Use the washer and screws provided.

Adjust hold-down brackets to desired position and tighten

screws to rough-in box. Insert adjusting screw into clamp

and secure cooktop to countertop.

NOTE:

For solid surface material installations: Insert a wooden

block between the end of the screw and the bottom of the

countertop. Do not overtighten adjusting screw. Trim

excess aluminum tape around cooktop flange.

9 WARNING

To avoid electrical shock hazard, before installing

the cooktop, switch power off at the service panel to

prevent the power from being switched on

accidentally.

Figure 3: Counter Cutout – Solid Surface Countertops

Heat Reflective Tape

Cutout shows location

of Aluminum Reflective Tape

Section "A - A"

Figure 4: Counter Cutout – Foam Tape Placement

Figure 5: Attaching Hold-Down Brackets

1/4”

(6.35mm)

Cutout

Foam

Tape

Rough-in Box

Foam

Tape

(Seal)

Adjusting

Screw

Adjusting

Screw

Clamp

Wooden Block

(to be used with

solid surfacing

material, i.e.

Surell™ and

Corian®)

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Comments to this Manuals

No comments

Bosch NGM5055UC Installation Manual Page 7

Comments to this Manuals

Related products and manuals for Cookers Bosch NGM5055UC