Bosch NGM5055UC Installation Manual download pdf (Page 8)

English 6

Connect Gas Supply

The gas inlet to the unit is located at the right rear of rough-

in box.

Install the pressure regulator (supplied with unit) to

manifold pipe using Teflon tape on threads of manifold

pipe. Turn to hand tighten plus 1/4 turn, not exceeding 1

turn for alignment. To prevent possible damage to the gas

pressure regulator, install it after the rough-in box is in its

permanent position. When the regulator is securely

installed on the manifold pipe, the conversion nut will be

easily accessible.

Connect the gas supply line to the unit pressure regulator

using a 1/2" flex gas line connector between manual shut-

off valve and pressure regulator. Always use a new flex

line.

Check supply line connections for leaks using a soap

solution. Do not use a flame of any sort.

1. Turn on gas.

2. Apply a non-corrosive leak detection fluid to all joints

and fittings in the gas connection between the shut-off

valve and the range. Include gas fittings and joints in

the range if connections may have been disturbed

during installation. Bubbles appearing around fittings

and connections indicate a leak.

3. If a leak appears, turn off supply line gas shut-off valve

and tighten connections.

4. Retest for leaks by turning on the supply line gas shut-

off valve. When leak check is complete (no bubbles

appear), test is complete.

5. Wipe off all detection fluid residue.

Important Notes for Gas Connection:

• The appliance and its individual gas shutoff valve must

be disconnected from the gas supply piping system

during any pressure testing of that system at test

pressures in excess of 1/2 psig (3.5kPa).

• The appliance must be isolated from the gas supply

piping system by closing its individual manual shut-off

valve during any pressure testing of the gas supply

piping system at test pressures equal to or less than 1/

2 psi (3.5kPa).

Connect Electrical Supply

Before connecting 5-foot (1.5 m) supply cord to wall

receptacle, make certain that gas shutoff valve and all

burner controls are in OFF position.

Figure 6: Rough-in Box Area

Figure 7: Pressure Regulator

9 WARNING

Do not attempt any adjustment of the pressure

regulator, except conversion to propane..

Opening for Gas

Connection and

Electrical Cord

for 30” models: 12 15/16” (313 mm)

for 36” models: 15 15/16” (389 mm)

C of Cutout

1”

Figure 8: Gas and Electrical Location

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

Bosch NGM5055UC Installation Manual Page 8

Comments to this Manuals

Related products and manuals for Cookers Bosch NGM5055UC