19
Operation
6 720 617 760 (2008/09)
B Briefly press to save the value.
B Press mode until the current room temperature is displayed.
5.4 Adjusting the installer level (for installers
only)
B Accessing installer level: Hold down mode for approx. 6 sec-
onds until – – – is displayed.
B Release the mode key and turn until the required param-
eter is shown:
– 5A p = Code
– 5b p = Heating circuit configuration
– 6A p = Adjust the integral room temperature sensor
– 6b p = Adjustment factor I
– 6C p = Amplification factor V
– 6d p = Maximum flow temperature
– 6E p = Mixer runtime
B Briefly press : The current value for the previously
selected parameter is displayed.
B Briefly press : The current value flashes.
B Turn to select the required value.
B Briefly press to save the value.
B Press mode until the current room temperature is displayed.
The installer level is exclusively designed for install-
ers.
Comments to this Manuals