Bosch 9000416647(8811) Specifications download pdf (Page 15)

aus

15

Timer programming

*

* depending on model

You can delay the start of the programme

in 1-hour steps up to 24 hours.

Open the door.

Switch on ON/OFF switch

1

.

Press

5

+ button until the digital

display

8

jumps to .

Press

5

+ or – button until the

displayed time corresponds with

your requirements.

Press START button

7

, timer

programming is activated.

To delete timer programming, press

the

5

+ or – button until

is indicated on the digital display.

You can change your programme

selection at any time until the

programme starts.

Close the door.

End of programme

The programme has ended when the

value

is indicated on the numerical

display

8

.

The end of the programme is also

indicated by an acoustic signal.

This function can be changed as follows:

Open the door.

Switch on ON/OFF switch

1

.

Hold down programme button A

and press START button

7

until on

the digital display is indicated.

Release both buttons.

Press programme button A until the

factory set value

is indicated on

the digital display .

To change the setting,

press programme button C .

Each time the button is pressed, the set

value increases by one level; when the

value of

has been reached, the

display jumps back to (off).

Press START button

7

, the set value

is saved.

Close the door.

Switching off the appliance

Short time after the end of the programme:

Open the door.

Switch off ON/OFF switch

1

.

Turn off the tap (not applicable

if Aqua-Stop fitted).

Remove the utensils when they have

cooled down.

Warning

At the end of the programme please open

the door fully and not partially when

emptying the dishwasher. Any escaping

water vapour could damage sensitive

worktops.

Interrupting the programme

Open the door.

Switch off ON/OFF switch

1

.

The LEDs go out. The programme

is saved.

If the door was opened on an appliance

which has a warm water connection

or is heated, first leave the door ajar

for several minutes and then close.

Otherwise, expansion (pressure) may

cause the appliance door to spring

open or water to run out of the

appliance.

To continue the programme, switch

on the ON/OFF switch

1

again.

Close the door.

Terminating the programme

(Reset)

Open the door.

Press START button

7

for

approx 3 sec.

is indicated

on the digital display

8

.

Close the door.

The programme sequence lasts

approx. 1 min.

is indicated on the digital

display

8

(buzzer sounds).

Open the door.

Switch off ON/OFF switch

1

.

Close the door.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments