Bosch SHU33A Technical Information Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 63
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
0 0 0 0
Figure 32/llus. 32
Figure 33/llus. 33
r English
(Special Features, Continued)
Premium Dispenser
1) Press and hold the right-most of the two
buttons labelled "Cancel Drain", as shown in
Figure 32, then press and hold the "On/Off
button. The LED display wilt show a number
between 0 and 6.
2) If your dishes are streaked after wash-
ing, press the right-most "Cancel Drain"
button until the display shows a lower
number.
3) If your dishes are spotted after washing,
press the right-most "Cancel Drain" button
until the display shows a higher number.
Delay Start
This feature allows you to delay the start of
the selected wash cycle for up tp 19 hours.
Front Control
1. Press the On/Off Button
2. Press the Delay Start button. Continue
pressing the Delay Start button until the LED
display shows the number of hours of delay
you desire.
3. Press the button for the desired wash
cycle. You can change the cycle at any time
during the delay.
Top Control
1. Open the dishwasher door far enough to
expose the control buttons.
2. Press the On/Off Button
3. Press the Delay Start button. Continue
pressing the Delay Start button until the LED
displays shows the number of hours of
delay you desire.
4. Press the button for the desired wash
cycle. You can change the cycle at any time
during the delay.
Top Rack Only Cycle
This cycte allows you to save energy,
water, and detergent by washing loads
small enough to fitl onty the upper rack. Note:
The Top Rack Only cycle does not reduce
wash time.
To use the Top Rack Only Cycle:
1. Load the upper rack. Figure 33 shows a
typical mixed toad placed correctly in the
upper rack.
2. Press the On/Off button.
3. Press the button for the desired wash
cycle.
4. Press the Top Rack Only button.
OptiMISERTM
This feature, used in coejunctoe with the
other wash cycles, reduces wash time by
about 30%. NOTE: OptiMISER TM isNOT used
with the Quick Wash or Rinse and Hold
cycles.
To useOptiMISERTM:
1. Press the On/Off button.
2. Press the desired cycle selection button.
(Continued on Next Page)
36 Special Features I Caracteristiques Speciales I Caractisticas Especiales
Page view 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 62 63

Comments to this Manuals

No comments