Bosch SKE53M05AU Specifications download pdf (Page 19)

en

19

– After installing the appliance, ensure

that the plug is easily accessible.

– Some models:

The plastic housing on the water

connection contains an electric valve,

the connecting cables are in the supply

hose. Do not cut through this hose,

do not immerse the plastic housing in

water.

Delivery

Your dishwasher has been checked

thoroughly in the factory to ensure that it is

in working order. This may cause small

water stains. These will disappear after the

first wash cycle.

Technical specifications

Weight:

max. 24 kg

Voltage:

220–240 V, 50 Hz or 60 Hz

Connected load:

2.0–2.4 kW

Fuse:

10/16 A

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing valve

ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

for cold water connection only.

Installation

The required installation dimensions can

be found in the installation instructions.

Level the appliance. Ensure that the

appliance is situated securely on the floor.

– The appliance can easily be

installed in a fitted kitchen between

wooden and plastic walls.

Waste-water connection

– The required work sequence can be

found in the installation instructions. If

required, fit a siphon with an drainage

connection.

– Connect the waste-water hose to the

drainage connection of the siphon with

the enclosed parts.

Ensure that the drainage hose is not

kinked, crushed or twisted and that

there is no cover plate in the drainage

to prevent the waste water from flowing

out!

Fresh water connection

– Connect the fresh-water connection to

the tap according to the installation

instructions with the enclosed parts.

Ensure that the fresh-water connection

is not kinked, crushed or twisted.

– When replacing the appliance, always

use a new water supply hose.

Water pressure:

at least 0.05 MPa (0.5 bar), maximum

1 MPa (10 bar). At a higher water

pressure: connect pressure-reducing valve

ahead.

Inlet rate:

minimum 10 litres/minute

Water temperature:

for cold water connection only.

Electrical connection

– Connect the appliance to an

alternating current only, ranging from

220 V to 240 V and 50 Hz or 60 Hz

via a correctly installed socket with

protective earth conductor. See rating

plate for required fusing 1Z.

– The socket must be near the appliance

and freely accessible following

installation.

If the plug is not freely accessible, an

allpole disconnector with a contact

opening of at least 3 mm must be

fitted on the installation side to satisfy

the relevant safety instructions.

1 2 ... 14 15 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments