Bosch SKE53M05AU Specifications download pdf (Page 12)

en

12

Aqua sensor

Aqua sensor *

* depending on model

The Aqua sensor is an optical measuring

device (light barrier) which measures the

turbidity of the rinsing water.

The Aqua sensor is used according to the

programme. If the Aqua sensor is active,

“clean” rinsing water can be transferred to

the next rinse bath and water consumption

can be reduced by 2–4 litres. If the

turbidity is greater, the water is drained

and is replaced with fresh water. In the

automatic programmes the temperature

and running time can also be adjusted to

the degree of soiling.

Switching on the appliance

– Turn on the tap fully.

– Switch on ON/OFF switch (.

The display of the last selected

programme flashes. This programme

remains selected if no other

programme button 0 is pressed. The

expected programme duration flashes

on the digital display `.

– Press the START button H.

The programme starts running.

Remaining running time display

When the programme is selected, the

remaining running time of the programme

is indicated on the digital display `.

The running time is determined during the

programme by the water temperature, the

number of utensils as well as the degree

of soiling and may vary (depending on the

selected programme).

Timer programming

Timer programming *

* depending on model

You can delay the start of the programme

in 1-hour steps up to 24 hours.

– Close the door.

– Switch on ON/OFF switch (.

– Press button 8 + until the digital

display ` jumps to œ:‹‚.

– Press 8 + or – button until the

displayed time corresponds with your

requirements.

– Press START button H, timer

programming is activated.

– To delete timer programming, press

the 8 + or – button until ` œ:‹‹ is

indicated on the digital display.

You can change your programme

selection at any time until the

programme starts.

End of programme

The programme has ended when the

value ‹:‹‹ is indicated on the numerical

display `.

Switching off automatically after the end of the pr ogramme

Switching off automatically after

the end of the programme *

* depending on model

To save energy, the dishwasher is

switched off 1 minute after the programme

ends (factory setting).

Automatic disconnection can be adjusted

from ˜:‹‹ to ˜:‹ƒ.

– Close the door.

– Switch on ON/OFF switch (.

– Hold down programme button # and

press START button H until š:‹... is

indicated on the digital display.

– Release both buttons.

– Press programme button # until the

factory set value ˜:‹‚ is indicated on

the digital display `.

To change the setting:

– Press programme button 3.

Each time the button is pressed, the

set value increases by one level; when

the value of ˜:‹ƒ has been reached,

the display jumps back to ˜:‹‹ (off).

– Press START button H.

The set value is saved.

Washing the dishes

˜:‹‹ Appliance does not switch off

automatically

˜:‹‚ Off after 1 min

˜:‹ƒ Off after 120 min

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Comments to this Manuals

No comments