Bosch PVP775FC1E Instruction Manual download pdf (Page 10)

en Operating the appliance

Residual heat indicator

The hob has a residual heat indicator for each hotplate.

This indicates that a hotplate is still hot. Do not touch a

hotplate while the residual heat indicator is lit up.

The following indicators are shown depending on the

amount of residual heat:

■ Display •: High temperature

■ Display œ: Low temperature

If you remove the cookware from the hotplate during

cooking, the residual heat indicator and the selected

heat setting will flash alternately.

When the hotplate is switched off, the residual heat

indicator will light up. Even after the hob has been

switched off, the residual heat indicator will stay lit for as

long as the hotplate is still warm.

1Operating the appliance

Oper at i ng the appl i anc e

This chapter explains how to set a hotplate. The table

shows heat settings and cooking times for various

meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.

To switch on: Touch the # symbol. An audible signal

sounds. The indicator next to the main switch and the

hotplate indicators ‹ light up. The hob is ready to use.

To switch off: Touch the # symbol until the indicator

goes out. All hotplates are switched off. The residual

heat indicator remains lit until the hotplates have cooled

down sufficiently.

Notes

■ The hob switches off automatically if all hotplates

have been switched off for more than 20 seconds.

■ The selected settings are stored for four seconds

after the hob has been switched off. If you switch it

on again during this time, the hob will operate using

the previously stored settings.

Setting a hotplate

Set the required heat setting using symbols ò to ê.

Heat setting ò = lowest setting.

Heat setting ê = highest setting.

Every heat setting has an intermediate setting. This

intermediate setting is marked in the control panel with

the Ø symbol.

Notes

■ To protect the fragile parts of your appliance from

overheating and electrical overloading, the hob may

temporarily reduce the power.

■ In order to prevent the appliance from producing

excess noise, the hob may temporarily reduce the

power.

Selecting a hotplate and heat setting

The hob must be switched on.

1. Touch the ø symbol for the required hotplate.

The ‹ symbol lights up and the ¬ symbol

underneath.

2. Then select the required heat setting from the

settings range.

The heat setting is set.





1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Bosch PVP775FC1E Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Hobs Bosch PVP775FC1E