Bosch Plena Voice Alarm System Service Manual download pdf (Page 47)

Bosch Security Systems | 2004-06 | 9922 141 10371en

Plena Voice Alarm System | Installation and Operating | Configuration en | 47

5 Configuration

5.1 Introduction

A number of functions within the system are hardware

configurable by DIP switches. However, most functions

are software configurable, using the Configuration

Software.

5.2 Hardware configuration

A complete Plena Voice Alarm System can be hardware

configured using:

• The system settings DIP switch (see section 5.3), the

VOX configuration (DIP) switches (see section 5.4.2)

and the master volume control knobs on the rear of

the controller.

• The CS configuration DIP switch (see section 5.5) on

the bottom of each call station.

• The ID rotary switch and the termination switch on

the rear of each router (see section 5.6).

5.3 System settings DIP switch

The system settings are configured using the system

settings DIP switch on the rear of the controller (see

figure 5.1). By default, all switches are in the OFF

position.

5.3.1 Monitor

If the Monitor switch (see figure 5.1) is in the ON

position, the internal monitoring loudspeaker of the

controller is switched on. The volume of the monitoring

loudspeaker is set with the Monitoring Speaker master

volume control knob (see figure 2.3, no. 35).

5.3.2 APR mode

If the APR mode switch (see figure 5.1) is in the ON

position, the system operates in the Asian-Pacific

Region (APR) mode. In APR mode, the system operates

according to the emergency standards of the Asian-

Pacific Region.

5.3.3 Supervision

If the Supervision switch (see figure 5.1) is in the ON

position, supervision is enabled. If it is in the OFF

position, supervision is disabled. To indicate that

supervision is disabled, the Disabled indicator on the

front panel of the controller is turned ON (see figure

5.2). For an overview of all functions that can be

supervised, see 5.3.3.1.

Note

Refer to the Configuration Software Manual

(9922 141 10381) for details about using the

software.

figure 5.1: System settings DIP switch

Monitor

APR mode

Supervision

2ch operation

LBB1994

Off

table 5.1: System settings DIP switch settings

DIP switch Description

Monitor Switches the monitoring

loudspeaker on (ON) or off (OFF).

See section 5.3.1.

APR mode Switches the Asian Pacific Region

mode on (ON) or off (OFF). See

section 5.3.2.

Supervision Switches supervision on (ON) or off

(OFF). See section 5.3.3.

2ch operation Switches 2-channel operation on

(ON) or off (OFF). See section 5.3.4.

LBB1994 For future use. This switch must

always be in the OFF position.

figure 5.2: Supervision: Disabled indicator

Processor reset

Network

Call/EMG

Music/Spare

Ground short

Input

Mains

Battery

Zone1

Zone2

Zone3

Zone4

Zone5

Zone6

Fault Indicators

Disabled

Message

EMG mic

RCP

Router

0dB

-6dB

-20dB

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 71 72

Comments to this Manuals

No comments

Bosch Plena Voice Alarm System Service Manual Page 47

Comments to this Manuals

Related products and manuals for Musical Equipment Bosch Plena Voice Alarm System