Bosch GOF 1300 CE Professional Operations Instructions download pdf (Page 24)

24 | English

1 609 929 N93 | (2.9.08) Bosch Power Tools

Certain dusts, such as oak or beech dust, are

considered as carcinogenic, especially in

connection with wood-treatment additives

(chromate, wood preservative). Materials

containing asbestos may only be worked by

specialists.

– Use dust extraction whenever possible.

– Provide for good ventilation of the work-

ing place.

– It is recommended to wear a P2 filter-

class respirator.

Observe the relevant regulations in your

country for the materials to be worked.

Mounting the Extraction Adapter

The extraction adapter 27 can be mounted with

the hose connection to the front or to the rear.

When the guide bushing adapter 44 is mounted,

it is possible that the guide bushing adapter

must be turned by 180° so that the extraction

adapter 27 does not touch the release lever 46.

When mounting with the hose connection in

front, the chip shield 6 must be removed first.

Fasten the extraction adapter 27 with the

2 knurled screws 28 to the base plate 12.

Connecting the Dust Extraction

Insert an extraction hose (Ø 35 mm) 26 (acces-

sory) into the mounted extraction adapter. Con-

nect the extraction hose 26 to a vacuum cleaner

(accessory).

The machine can be plugged directly into the re-

ceptacle of a Bosch all-purpose vacuum cleaner

with remote starting control. The vacuum clean-

er starts automatically when the machine is

switched on.

The vacuum cleaner must be suitable for the ma-

terial being worked.

When vacuuming dry dust that is especially det-

rimental to health or carcinogenic, use a special

vacuum cleaner.

Mounting the Chip Shield (see figure C)

Insert the chip shield 6 from the front into the

guide in such a manner that it engages. To re-

move the chip shield, grasp it by the sides and

pull it off toward the front.

Operation

Starting Operation

f Observe correct mains voltage! The voltage

of the power source must agree with the

voltage specified on the nameplate of the

machine. Power tools marked with 230 V

can also be operated with 220 V.

Preselecting the Speed

The required speed can be preselected with the

thumbwheel 3 (also while running).

1 – 2 low speed

3 – 4 medium speed

5–6 high speed

The values shown in the chart are standard val-

ues. The necessary speed depends on the mate-

rial and the operating conditions, and can be de-

termined by practical testing.

After longer periods of working at low speed, al-

low the machine to cool down by running it for

approx. 3 minutes at maximum speed with no

load.

Material Router bit di-

ameter (mm)

Thumb-

wheel 3

Hardwood (Beech)

4–10

12 – 20

22 – 40

5–6

3–4

1–2

Softwood (Pine)

4–10

12 – 20

22 – 40

5–6

3–6

1–3

Particle Board

4–10

12 – 20

22 – 40

3–6

2–4

1–3

Plastics

4–15

16 – 40

2–3

1–2

Aluminium

4–15

16 – 40

1–2

1

OBJ_BUCH-203-003.book Page 24 Tuesday, September 2, 2008 8:46 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 296 297

Comments to this Manuals

No comments