Bosch 4412 User Manual download pdf (Page 18)

18.

Mounting the Saw

Setting Main Handle in Desired Position

The switch handle can be positioned in any of four

different orientations, depending on the cutting

situation and user preference.

● vertical

● horizontal

● 45° Left

● 45° Right

To reposition the main handle:

1. Release handle clamp (Figure 16).

2. Pull and hold handle rotation release lever

(Figure 16).

3. Rotate handle to desired location.

4. Let go over release lever to set handle into

place. Release lever will retract down only in

one of the four (4) positions

Note: Power switch can not be actuated unless

release lever is retracted down. Do not attempt to

switch tool on between handle position, damage may

occur.

5. Lock the handle clamp.

Adjusting the Four-Position Handle

Clamp Tension

1. Open handle clamp.

2. Using 1.5 mm Allen wrench, increase tension by

turning both setscrews 1/4 turn to the left, tighten

by turning to the right. Always adjust both

setscrews by the same amount.

3. Close handle clamp.

4. Check the tension.

Figure 16. Setting Main Handle Position

Adjusting the Four Position

Switch Handle

Portable Mounting Using Clamps

— If necessary, clamp the miter saw to a workbench

or table top.

— Place two (2) or more “C” clamps on the clamping

areas and secure (Figure 15).

— Be careful not to place clamps over the base

extension clamping levers (Figure 15).

— Mounting with clamps will prevent access to some

wide miter angles.

Figure 15. Portable Mounting Using Clamps

Clamping Areas

Clamping

Areas

Pull to Rotate Handle

Handle

Clamp

Handle Rotation

Release Lever

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 103 104

Comments to this Manuals

No comments

Bosch 4412 User Manual Page 18

Comments to this Manuals

Related products and manuals for Power saws Bosch 4412