Bosch GHO 26-82 Operations Instructions download pdf (Page 8)

EURO • BA 2 609 140 180 • GHO 26-82 • GB • OSW 02/04

English - 3

Planing (see figure )

Set the required planing depth and place the front

part of the planer shoe 11 against the workpiece.

Caution! Danger of kickback!

Apply the machine to the workpiece

only when switched on.

Switch the machine on and guide the machine

with an even feed over the surface to be planed.

To achieve high-grade surfaces, work only with

low feed and apply pressure on the centre of the

planer shoe.

When machining hard materials (e. g. hardwood)

as well as when utilising the maximum planer

width, set only low planing depths and reduce

planer feed, as required. Repeat the planing sev-

eral times.

Excessive feed reduces the surface quality and

can lead to rapid clogging of the chip ejector.

Only sharp blades achieve good cutting capacity

and give the machine longer life.

Continuing interrupted planing

The integrated blade protector 21 also allows for

continued planing at any given location on the

workpiece after an interruption:

– With the blade protector folded down, place

the machine on the location of the workpiece

where the planing is to be continued.

– Switch the machine on.

– Apply the supporting pressure onto the front

part of the planer shoe and slowly push the

machine forwards (

➊). This tilts the blade pro-

tector 21 up (

➋) so that the rear part of the

planer shoe 11 faces on the workpiece again.

– Guide the machine alongside the surface to be

planed (

➌) with an even feed.

Beveling Edges

The V-grooves 12 in the front planer shoe 11 al-

low quick and easy beveling of workpiece edges.

Depending on required bevel width, use the cor-

responding V-groove.

For this, place the planer with the V-groove 12

onto the edge of the workpiece and guide along

the edge.

Using the Parallel/Angle Guide

(Accessory)

Mount parallel guide 13 or angle guide 17 to the

machine using fastening bolt 14 and rebating

depth stop 2 using fastening bolt 1.

Loosen locking nut 15 and adjust the required re-

bating width with the scale 16. Retighten locking

nut 15 again.

Adjust the required rebating depth accordingly

with the rebating depth stop 2.

Carry out the planing procedure several times,

until the required rebating depth is reached. Pay

attention that the planer is guided with sideward

supporting pressure.

Beveling (only angle guide 17)

When beveling rebates and surfaces, adjust the

required slope angle with the angle adjust-

ment 18.

B

45°

12

82 mm

max

9 mm

max

2 609 140 180.book Seite 3 Mittwoch, 3. April 2002 9:19 09

13 • 2 609 140 180 • TMS • 08.03.02

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments