Bosch GHO 26-82 Operations Instructions download pdf (Page 10)

English | 19

Bosch Power Tools 1 609 929 M03 | (17.9.07)

Only sharp blades achieve good cutting capacity

and give the machine longer life.

The integrated park rest 26 also allows for con-

tinued planing at any given location on the work-

piece after an interruption:

– With the park rest folded down, place the ma-

chine on the location of the workpiece where

the planing is to be continued.

– Switch on the machine.

– Apply the supporting pressure onto the front

part of the planer base plate and slowly push

the machine forward (n). This tilts the park

rest upward (o) so that the rear part of the

planer base plate faces on the workpiece

again.

– Guide the machine over the surface to be

planed (p) with even feed.

Beveling Edges (see figure H)

The V-grooves in the front planer base plate allow

quick and easy beveling of workpiece edges. De-

pending on required bevel width, use the corre-

sponding V-groove. For this, place the planer

with the V-groove onto the edge of the workpiece

and guide it along the edge.

Planing with Parallel/Beveling Guide

(see figures D–F)

Mount the parallel guide 18 or beveling guide 22

to the machine using the corresponding fasten-

ing bolt 21. Depending on the application, mount

the rebating depth stop 25 with fastening bolt 24

to the machine.

Loosen the locking nut 20 and adjust the request-

ed rebating width on the scale 19. Tighten the

locking nut 20 again.

Adjust the requested rebating depth accordingly

with the rebating depth stop 25.

Carry out the planing procedure several times un-

til the requested rebating depth is reached.

Guide the planer applying sideward supporting

pressure.

Beveling with the Beveling Guide

When beveling rebates

and surfaces, adjust the

required slope angle

with the angle adjust-

ment 23.

Maintenance and Service

Maintenance and Cleaning

f Before any work on the machine itself, pull

the mains plug.

f For safe and proper working, always keep

the machine and ventilation slots clean.

Ensure easy operation of the park rest 26 and

clean it regularly.

When the carbon brushes wear below acceptable

service tolerances, the machine will automatical-

ly cut out. The machine must be sent to customer

service for maintenance (for address, see the “Af-

ter-sales service and customer assistance” sec-

tion).

If the machine should fail despite the care taken

in manufacturing and testing procedures, repair

should be carried out by an after-sales service

centre for Bosch power tools.

In all correspondence and spare parts order,

please always include the 10-digit article number

given on the type plate of the machine.

Groove to be

used

Dimension a

(mm)

none 0

– 4

small 2

– 6

medium 4 – 9

large 6 – 10

OBJ_BUCH-446-001.book Page 19 Monday, September 17, 2007 10:34 AM

1 2 ... 5 6 7 8 9 10 11

Comments to this Manuals

No comments