Bosch JS365 Specifications download pdf (Page 11)

Choose blades carefully, as the ability of the

jigsaw to follow curves, provide smoother

finishes, or faster cutting is directly related to

the type of blade used (See your Bosch

Dealer).

For tight curves it is best to use a narrow or

scroll blade.

When sawing metal or similar materials, shut

off chip blower and apply coolant/lubricant

alongside the cutting line.



Plunge cutting is useful and time-saving in

making rough openings in softer materials. It

is not necessary to drill a hole for an inside or

pocket cut. Draw lines for the opening, hold

the saw firmly, tilt it forward so that the toe of

the saw foot rests on the work, but with the

blade well clear of the work. Start the motor,

and then very gradually lower the blade.

When it touches, continue pressing down on

the toe of the saw foot slowly pivoting the saw

like a hinge until the blade cuts through and

the foot rests flat on the work. Then saw

ahead on the cutting line. We do not

recommend plunge cutting with a scroll blade

(Fig. 9).

To make sharp corners, cut up to the corner,

then back up slightly before rounding the

corner. After the opening is complete, go back

to each corner and cut it from the opposite

direction to square it off. Do not try to plunge

cut into hard materials such as steel.



38-2'09()(%:%-0%&0)%7%'')7736=

This (JA1010) accessory is available at an

extra cost. It is used for fast and accurate

straight and circle cutting (Fig. 10).



1. Insert bar of guide through lock knob clamp,

then through the slots provided in foot, from

either side of foot with the edge guide facing

UP (Fig. 10).

2. Hook lock knob clamp onto edge of

footplate, adjust fence to desired width, and

securely tighten lock knob clamp (Fig. 10).

!

#

1. Insert bar of guide through lock knob clamp,

then through the slots provided in foot, from

either side of foot with the edge guide facing

DOWN (Fig. 11).

2. Place slot in guide onto guiderail.

3. Hook lock knob clamp onto edge of

footplate, adjust fence to desired width, and

securely tighten lock knob clamp (Fig. 11).

-11-

EDGE GUIDE UP

LOCK KNOB

CLAMP

FIG. 10

EDGE GUIDE

DOWN

GUIDERAIL

SLOT

FIG. 11

FIG. 9

BM 1609P07165 08-11:BM 1609P07165 08-11 8/10/11 8:58 AM Page 11

1 2 ... 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Bosch JS365 Specifications Page 11

Comments to this Manuals

Related products and manuals for Power tools Bosch JS365