Bosch RN175 Specifications download pdf (Page 10)

10.

Firing Modes

This tool is equipped with a “Bump” Fire trigger (Red), and a

“Sequential” Fire Trigger (Grey) is provided with your tool.

Select the correct actuation mode for your application and

xperience, see “Trigger Removal” and “Trigger installation”

to remove and install trigger.

“Bump” Firing Mode:

To use the tool to drive nails in this actuation mode, a

“

Bump” Fire Trigger (Red) must be installed. The work

contact element and trigger can be actuated in any order.

1. Pull and hold the trigger with the tool off the work piece.

2. Press the work contact element against the work piece. A

nail will be driven, figure 9.

3. The tool must be allowed to recoil away from the work

piece.

The tool must be allowed to recoil away

from the work piece. Do not drive a nail

on top of another nail. If the tool is not moved before the

trigger is pulled again a second nail will be driven on top of

the previously driven nail. This could cause the nail to be

deflected or the tool to react in an unexpected manner.

4. Move the tool along the work piece with a bouncing

motion. Each time the work contact element is depressed

a nail will be driven, figure 9.

5. As soon as the desired number of nails has been driven,

remove finger from trigger.

Remove finger from the trigger when not

driving nails. Always carry the tool by the

handle only. Removing your finger from the trigger when

not operating the tool reduces the risk of unintentionally

firing a nail and injuring yourself or someone else.

“Sequential” Firing Mode:

To use the tool to drive nails in this actuation mode only, a

“Sequential” Fire Trigger (Grey) must be installed. The work

contact element and trigger must be used in a specific

order:

1. The work contact element must be completely depressed

by placing the nose of the tool against the work piece,

figure 10.

2. The trigger must be pulled firmly and then released,

figure 10.

3. The tool must be allowed to recoil away from the work

piece.

To continue operation in a separate location, move the tool

along the work piece, repeating steps 1 through 3 as

required.

Operation

WARNING

FIG. 9

FIG. 10

BM 2610957383 06-09:BM RN175 03-09 6/22/09 8:01 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 41 42

Comments to this Manuals

No comments

Bosch RN175 Specifications Page 10

Comments to this Manuals

Related products and manuals for Power tools Bosch RN175