Bosch KDD74AL20N Frigo-congelatore da libero posizioname User Manual download pdf (Page 9)

en

9

1. Position the appliance in the intended

installation area.

2. Screw the front feet out until they

stand firmly on the ground and align

the appliance at the front.

3. Use a spirit level to check that the

appliance is horizontal.

Note

The front feet must stand firmly on the

ground so that the appliance does not

roll away.

Connecting the

appliance

After setting up the appliance, wait for at

least one hour before starting the

appliance up. The oil contained in the

compressor may have been displaced

into the refrigeration system during

transport.

Before starting the appliance up for the

first time, clean its interior (see section

“Cleaning the appliance”).

Electrical connection

The socket must be near to the

appliance and easily accessible after the

appliance has been installed.

The appliance conforms to protection

class I. Connect the appliance to a

220-240 V/50 Hz alternating current

supply using a socket with protective

earthing conductor which has been

correctly installed. The socket must be

protected by a fuse with a rating of 10 A

to 16 A.

In the case of appliances operated

outside of Europe, check whether the

voltage and type of current specified

conform to the values of your electricity

grid. You will find this information on the

rating plate. Figure ,

m Warning

The appliance must never be connected

up to an electronic energy-saving socket.

Sinusoidal-commutated and line-

commutated inverters can be used with

our appliances. Line-commutated

inverters are used with photovoltaic

systems that are connected directly to

the national grid. Sinusoidal-

communicated inverters must be used

with standalone applications (e.g. on

ships or mountain huts) that do not have

a direct connection to the national grid.

Attaching handles

Figure &

Only attach the handles once the

appliance has been positioned in its

installation location and has been

aligned so that it is level.

1. Push the holders into the guides.

2. Position and tighten the screws.

3. Push the handles onto the holders and

slide them downwards. The "Top"

sticker must be facing upwards.

4. Position and tighten the screw.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 108 109

Comments to this Manuals

No comments