Bosch D1260 User Manual download pdf (Page 25)

100

D1260/D1260B | Owner's Manual | Part II: System Commands - WALK TEST ? (COMMAND + 4 + 4)

Bosch Security Systems | 9/04 | 50410D 25

4. Your system displays event summary lines and

point text in this order:

a. fire alarm summary line

b. point text for each fire alarm event

c. alarm summary line

d. point text for each alarm event

e. fire trouble summary line

f. point text for each fire trouble event

g. trouble summary line

h. point text for each trouble event.

5. Press NEXT> to scroll through the events.

If there are no events to view,

There are

currently no events in memory

displays.

6. You can return to idle text at any time by pressing

Exit> soft key.

WALK TEST ? (COMMAND + 4 + 4)

Walk Test

Description

Use this function to test keypads, detection devices,

and sounders (both interior and exterior) to be certain

they function properly. You can review untested points

at your keypad to help pinpoint any problems.

You cannot arm your system while in the walk test

mode, and no alarm reports are sent to your security

company unless a 24-hour point is activated (such as

fire or panic). A Walk Test Start Report may be

programmed to be sent to your security company.

Upon initiation, the walk test will test the burglary bell

pattern on the bell output and ring the keypad burglary

bell for 2 seconds. The AC will be disabled for 4

minutes in order to test the system’s battery power. If

the battery cannot maintain the system for the 4-minute

period, the keypad will appear to go dead. If your

keypads are programmed to be supervised, the main

alarm panel will beep intermittently during this 4-

minute period. If this happens, contact your security

company. At the end of the 4-minute period, AC is

returned to the system and the panel restores. To test

individual detection devices, simply activate sensors

and open protected doors and windows one-at-a-time.

As each detection device is faulted, the Keypad emits a

brief tone and the display indicates for 60 seconds that

the point has been tested. This verifies that each

detection device is working properly.

Using Walk Test:

1. The display shows disarmed idle text.

2. Press the COMMAND key. The display shows

*System Command*

3. Press the 4 key and then the 4 key.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 99 100

Comments to this Manuals

No comments

Bosch D1260 User Manual Page 25

Comments to this Manuals

Related products and manuals for Safety Bosch D1260