Bosch PT-400 User Manual download pdf (Page 13)

Security Escort | Technical Reference Manual | 2.0 Setting Up The

System

EN | 13

Bosch Security Systems | 6/12 | 38947D

2.0 Setting Up The System

2.1 Initial System Configuration

The default password is PPP. The

default password, the Master password,

and passwords for all system operators

added by referring to the Operators

Database in the Security Escort

Operations Manual should be changed.

 To generate the map file for the

screen display, refer to Section 5.1

Map File Generation and Scaling.

 To setup the transponder COMM ports

refer to the Section 3.3.18

Transponder Comm Port Setup Screen.

 To setup the system COMM ports refer

to the Section 3.3.19 Remote Comm

Port Setup Screen.

 To set the function of the system

COMM ports and setup remote access,

see Section 3.3.20 Remote Setup

Screen.

 To program the system configuration,

see Section 3.1.6 Transponder

Database.

 To program the system responses to

an alarm, see Section 3.2.3 Security

Preferences Screen.

 To program the system responses to

troubles, see Section 3.3.3 Popup

Trouble Filter.

 After communications to the

transponders are established for any

transponder that uses a Proxim Radio

to communicate, program the Uses

Proxim Radio field in the

Transponder Parameter Change Screen.

If all alarms are to be silent,

program the Run Silent field. (See

Section 3.3.11 Transponder

Parameter Change Screen.)

 If this system has master and slave

computers, set the Default Master

Computer and Default Slave Computer.

(See Section 3.3.20 Remote Setup

Screen.)

 If using pager access in this

system, see Section 3.3.23 Pager

Setup Screen.

 If this computer runs other programs

at the same time, Security Escort is

running, set the Not Always Top

Window field (see Section 3.2.3

Security Preferences Screen).

 To program the ID Receiver to

automatically enter the transmitter

IDs, see Section 3.2.3 Security

Preferences Screen.

 To set the names of the subscriber

classes, see System Default Screen

in the Security Escort Operations

Manual.

 To program the transmitters into the

Subscriber Database, refer to the

Security Escort Operations Manual.

3.0 System Menus and

Screens

3.1 File Menu

Figure 4: File Menu

3.1.1 Locate Transmitters

This selection allows the operator to

display the last reported location of

the transmitter assigned to the

indicated individual or asset. When the

individual or asset is selected from

the list, the time of the last

supervision report is shown (or None is

displayed if no supervision report was

received from that transmitter). On the

map, the last report location is shown.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

Comments to this Manuals

No comments