Bosch UPH-3D User Manual download pdf (Page 9)

CTFID Connections | en 9

Bosch Security Systems, Inc. User’s Manual F.01U.173.603 | 3.12 | 2010.11

3.2 Connecting via Serial port (VP-RS2BLNX Configuration Tool)

It is recommended that the CTFID software be installed before connecting the hardware to

the serial port. Refer to Section 2 Installing the CTFID Software, page 5 for additional

information.

To see the device output, use a CCTV monitor. Plug the coax connected to the imaging device

to one of the BNC connectors of the VP-RS2BLNX (which can operate in either RS-232 or RS-

485 mode). Connect another coax between the second BNC connector and the CCTV monitor.

Ensure that the monitor is either auto-terminating or is set to low impedance. See Figure 3.3

for an example of a typical CCTV monitor’s connections.

Figure 3.2 VP-RS2BLNX connections

Figure 3.3 Connecting the VP-RS2BLNX Configuration Tool

Number Description

1 Power and serial connection

2 Selects mode and baud rate

3 BNC connections, passive loop-through, high impedance, video input 1 Vpp nominal,

2Vpp max.

Number Description

1 Typical AutoDome version 5.10 or higher, and any other Bilinx device

2Coax IN

3 Terminal block

4VP-RS2BLNX

5 PC running CTFID software

6 RS-232

7 Power supply (not provided)

8Coax OUT

9 Typical CCTV monitor

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

No comments

Bosch UPH-3D User Manual Page 9