Bosch WTU876B9SN Instruction Manual download pdf (Page 49)

Help with the appliance en

3 Help with the appliance

Help with the appliance

Faults Cause/remedy

The appliance will not

start.

Check the mains plug and the fuses.

Creasing. ■ Load exceeded or incorrect programme selected for a type of fabric. All the

required information can be found in the programme table.~ Page 23

■ Remove laundry from the drum as soon as the drying programme has fin-

ished. Creasing occurs when clothing is left in the drum.

Water is leaking out. ■ The appliance may be positioned at an angle. Level the appliance.

■ In the base unit, make sure that:

– The heat exchanger cover is properly locked.

– There is no dirt or debris on the heat exchanger cover's seal.

~ Page 41

■ If the optional drain hose* is installed, make sure that the drain hose is cor-

rectly connected. ~ Page 36

Programme duration dis-

played changes as dry-

ing progresses.

Not a fault. The moisture sensor measures the residual moisture in the laundry

and adjusts the programme duration (with the exception of timed programmes).

Laundry is not dried

properly or is still too

damp.

■ After the programme has ended, warm laundry feels damper than it actually

is. Spread out the laundry and let it cool down.

■ Adjust the drying time or increase the degree of dryness. This will extend

the drying time but the temperature will remain the same.

■ Select a timed programme to add extra drying time for laundry that is still

damp.

■ Select a timed programme for a small load.

■ Do not exceed the maximum load for a programme.~ Page 23

■ Clean the moisture sensor in the drum. The sensor may become covered in

a fine layer of limescale or detergent and care product residue, which then

impairs its performance.~ Page 40

■ Drying has been interrupted as a result of a power cut, because the conden-

sation container is full or because the maximum drying time has been

exceeded.

Note: See also the laundry tips.~ Page 27

The programme will not

start

Make sure that:

■ The door is closed.

■ E 3sec (Child lock) has been deactivated

■ You have pressed A (Start/Pause)

Note: If the programme has been delayed by setting ñ (Ready in), the pro-

gramme will start later.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments

Bosch WTU876B9SN Instruction Manual Page 49

Comments to this Manuals

Related products and manuals for Washing machines Bosch WTU876B9SN