Bosch BC3200RA5 Operations Instructions download pdf (Page 28)

2828

Operating Instructions

* The shapes of the drain plugs are as on the right.

* The drain plugs may not be clearly visible as they are partially hidden

behind the pipe insulation.

* Water may not drain out fully even though the drain plugs are loosened,

depending on the pipe arrangement. In this case, fully remove the drain

plugs. (Make sure not to mislay them.)

Position of the drain plugs

5 positions

If the water heater will not be used for a long period of time,

Drain the water-2.

Turning the Unit Back On

1. Check that all drain plugs are inserted.

2. Check that all hot water fixtures are closed.

3. Follow the procedure on P12 “Initial operation”, steps 1 through 4.

4. Make sure that the area around the appliance is well ventilated; open a window or a door if necessary.

Then, operate the unit and verify that condensate is coming out of the drain pipe.

(During normal use of the water heater, condensate will begin to discharge from the drain pipe within 15

minutes of use. However, depending on the season and/or installation site conditions, it may take longer.)

* If water does not appear at the end of the drain line, a qualified service technician must clean the

condensate line.

After the water heater has been out of use for a long time or after replacing the

neutralizer with a new unit, make sure that you fill the neutralizer unit with water.

This is to prevent dangerous exhaust gases from entering the building.

Failure to fill the neutralizer unit could result in severe personal injury or death.

(By performing step 4 as described above, the neutralizer unit will automatically fill itself with water.)

Be sure to do.

DANGER

When Unused for an Extended Period

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

No comments

Bosch BC3200RA5 Operations Instructions Page 28