Bosch Appliances Security Camera LTC 9384 User Manual download pdf (Page 12)

LTC 9384 Series | Instruction Manual | Installation

Bosch Security Systems | September 1, 2004

For 24 Volt Cameras:

1. Installing a 24 volt camera into the LTC 9384/50

housing uses the internal transformer for camera

power (see FIGURE 11).

2. Connect the supply (230VAC) to the terminal

block. Use only the terminal block provided for

this connection.

3. Connect the secondary flying leads to the camera's

24 volt input. Refer to the wiring diagram for

clarification.

FIGURE 11 LTC 9384/50 Transformer Wired for

24 Volt Camera

5.7 Video Coax Connection

WARNING: Use only the cables specified

under INSTALLATION, Cable Requirements

for video coax wiring connection.

If no lens control or feed-through wires will be used:

1. Install the seal cap portion of the large liquid-

tight fitting on the video coax cable, and pull

the cable through the right-hand fitting on the

rear of the cradle. If lens control is used, pull

the cable through the small bottom fitting.

2. Attach the BNC connector to the coax and

connect it to the camera. Pull any excess wire

out of the cradle assembly and tighten

approximately 1 to 11⁄2 turns past the point

where the fitting starts to grip the wire. Failure

to do so will result in water damage to all

electronic parts. Use a tie wrap (included) to

provide strain relief on the video cable at the

exit point (inside the unit).

3. Install the 3⁄8in. NPT plug provided in the

unused, small top center NPT hole.

Securely tighten all fittings to ensure a liquid-

tight seal. Failure to do so could allow water to

enter the housing and damage the camera and

lens.

5.8 Lens Wiring

WARNING: Use only the cables specified

under INSTALLATION, Cable Requirements

for video coax wiring connection.

1. If installing a zoom lens, insert the lens

control cable with the installed seal cap in

through the right fitting at the rear of the

cradle. Attach the lens wiring to the lens

mating connector and connect it to the lens. If

the mating connector is not available, connect

directly to the lens cable.

NOTE: See the specification on lens cord for

the correct plug connection.

Securely tighten all fittings to ensure a liquid-

tight seal. Failure to do so could allow water to

enter the housing and damage the camera and

lens.

2. If using a pan/tilt with a feed-through cable,

insert the camera/lens function cable in

through the right-hand fitting at the rear of the

cradle. Wire the functions as described above

or as needed.

Use of drip loops is not recommended on the

wiring outside of the rear endcap.

5.9 Final Assembly

5.9.1 Pull Seal Installation

If the breather hole is open, do NOT mount the

housing in a position where the front endcap is

pointed upward.

To maintain enclosure protection ratings of NEMA-6P

and IP68, the pull seal (provided in the hardware kit)

must be installed in the front endcap. Install the pull seal

in a cool, dry environment to prevent trapping moisture

inside the housing (see FIGURE 12).

NOTE: Pull seal installation allows the housing's front

endcap to be pointed upward.

Brown

Red

To Camera

Blue

Red

24 VAC

230 VAC

Input

White/

Black

Striped

White/

Black

Striped

To Heater/Defogger

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Bosch Appliances Security Camera LTC 9384 User Manual Page 12

Comments to this Manuals

Related products and manuals for Camera housings Bosch Appliances Security Camera LTC 9384