Bosch Appliances Security Camera LTC 9384 User Manual download pdf (Page 13)

LTC 9384 Series | Instruction Manual | Installation

Bosch Security Systems | September 1, 2004

FIGURE 12 Breather Hole

Proper installation of the pull seal is as follows:

1. Remove the cradle assembly from the housing.

2. Obtain a rubber pull seal (Part Number

315 2569 001) from the hardware kit (see

FIGURE13). An extra pull seal is also provided.

FIGURE 13 Pull Seal

3. Insert the long end of the pull seal into the

breather hole starting from the front of the

endcap (see FIGURE 14).

FIGURE 14 Inserting the Pull Seal

4. Grip the pull seal's long end from the back of

the front endcap. Steadily pull the long end until

the head of the pull seal is flat against the front

of the endcap (see FIGURE 15).

NOTE: The pull seal's long end will stretch

when pulled through the breather hole.

FIGURE 15 Installing the Pull Seal

5.9.2 Cradle Assembly

1. Position the housing vertically and replace

the cradle assembly by applying pressure

onto the rear cap until the end of the cradle

is approximately flush with the back of the

housing (see FIGURE 16).

FIGURE 16 Inserting the Cradle Assembly

CAUTION: If a pull seal is installed in the

breather hole, be careful not to pinch the head of

the pull seal. Damage to the pull seal may allow

water to enter the housing, causing damage to

the camera and lens.

2. Tighten the retention screw, making sure it is

seated into the rear cap groove. If the housing

needs to be tamper-resistant, the LTC 9380/02

(purchased separately) should be installed at this

time.

3. Attach the housing to the appropriate mount

or pan/tilt per the instructions provided.

According to the orientation of the housing, the

cradle assembly may need to be rotated. To

rotate the cradle assembly (while mounted),

grasp the rear handle and rotate it to the desired

position. View the monitor while rotating.

Long End

Head

Front of

Endcap

Pull Seal

Breather Hole

Cradle

Front Face

Breather Hole

Front Endcap

Rear Face of Head Should

Be Flush with Front Face

of Front Endcap

Grip and Pull

1 2 ... 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Bosch Appliances Security Camera LTC 9384 User Manual Page 13

Comments to this Manuals

Related products and manuals for Camera housings Bosch Appliances Security Camera LTC 9384