Bosch base 2500 Operations Instructions download pdf (Page 15)

22 | English

1 609 929 S19 | (4/1/09) Bosch Power Tools

Extending the Saw Stand

(see figure J)

The saw stand can be extended on both sides.

– Place your long workpiece onto the saw table

of the power tool.

– Release the respective locking knob 4 as re-

quired, and pull the table extension 5 out to

the desired position.

– Retighten the locking knobs again.

Sawing Workpieces of the Same Length

(see figure K)

The length stop 11 can be used for easily sawing

workpieces to the same length.

– Pull the length stop upward to the stop and

position the workpiece support at the de-

sired clearance to the saw blade of the pow-

er tool.

Checking and Adjusting the Basic

Adjustment

After intensive use, the basic settings of the saw

stand must be checked and reset as required, to

ensure safe and proper function.

Experience and appropriate specialty tools are

required for this.

– Remove the power tool with the attachment

sets.

Adjusting Lock 9

(see figure L)

Over time, the lock 9 of support 8 can become

loose.

– Close lock 9.

– Insert a slotted screwdriver between the saw

stand and nut 27.

– Turn the lock in clockwise direction until the

lever for locking can be firmly closed again.

– Remove the slotted screwdriver and check

the adjustment again.

Adjusting the Limit Bolts of Lock 3

(see figures M1 –M2)

Checking:

– Bring the saw stand into the working position

(completely pulled apart).

Both limit bolts 20 must be completely extend-

ed and without a gap between limit bolts and

locking plate 21.

Adjusting:

– Open nuts 28 (16 mm) a quarter turn on

each side of the stand base.

– Tighten the adjustment screw 29 on the side

that has a gap between limit bolt and locking

plate.

If this does not reduce the gap, loosen the

adjustment screw on the other side.

– Repeat the procedure until both limit bolts

are completely extended again and no gap is

between the limit bolts and the locking plate.

– Tighten nuts 28 again.

Transport

The stand base must be folded together for

transport. (see figure N)

– Slide the table extensions 5 all the way in as

well as the workpiece supports 12 and the

length stops 11 all the way down.

– Release lock 9.

– To relieve the limit bolts 20, lightly push the

saw stand downward by the handle 6.

– Release lock 3.

This pulls back the limit bolts that lock the

wheels in place.

– Position one foot on the foot lever 14 and

pull the handle 6 upward with both hands un-

til the limit bolts can engage again on the oth-

er side of the locking plates 21.

– Close the lock 3.

OBJ_BUCH-854-002.book Page 22 Sunday, January 4, 2009 12:35 PM

1 2 ... 10 11 12 13 14 15 16

Comments to this Manuals

No comments