Bosch DIW116750 Installation Manual download pdf (Page 27)

27

Installation

❑

The support frame is marked with

"FRONT" on one side. This is side

where the switches for the extractor

hood will be after installation has

been completed.

6. Screw two hex bolts from underneath all

the way into the threaded holes in the

extractor hood.

Screw nuts onto the bolts, leaving a gap

of approx. 4 mm.

7. Lift up the extractor hood and hook the

protruding nuts into the key-hole slots

and secure the hood in place with 2 hex

bolts inserted from above into the holes

at the corners on the opposite side.

565

310

200

3

4

6

,4

175

This extractor hood is intended to be

mounted either directly onto the kitchen

ceiling or onto a stable, suspended ceiling

structure.

See Technical Data for weight of the

extractor hood.

 Ensure that the minimum distance

between the hob and the extractor hood is

maintained – 550 mm for an electric hob and

650 mm for a gas hob.

1. Mark the centre of the position on the cei-

ling at which the hood will be mounted.

2. Use the template to mark the position of

the holes for the mounting screws.

3. Drill 4 x l 8 mm holes and insert plugs

into the holes so that they are ﬂush with

the ceiling.

4. Assemble the support frame (8 screws).

 The overall length of the support frame

for the standard chimney panelling

enclosed with the hood is 565 mm. In the

case of longer cover panels, the length of

the support frame can be adjusted in steps

of 20 mm (from at least 425 mm up to max.

of 725 mm for the exhaust-air version and

from at least 505 mm up to max. of 725 mm

for the recirculating version).

5. Mount the support frame onto the ceiling.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 99 100

Comments to this Manuals

No comments